Automated Pet Care Products LITTER-ROBOT Panduan Pengguna - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Produk Perawatan Hewan Peliharaan Automated Pet Care Products LITTER-ROBOT. Automated Pet Care Products LITTER-ROBOT 19 halaman. Self-cleaning litter box
Juga untuk Automated Pet Care Products LITTER-ROBOT: Manual (16 halaman), Manual (18 halaman)

Halaman Cetak

Cleaning & Maintenance

The Litter-Robot requires no special maintenance. We

recommend that you do not lubricate the four plastic

'glide buttons' on the Base unit. Lubricating these glide

buttons will cause dirt to build up.

Before you clean the Litter-Robot please make sure that

you remove all litter from the Globe - wet litter turns

into messy clay.

Emptying the Litter-Robot

Look through the Cat Entry opening and locate the

ribbed handle of the Internal Guard on the right, inside

the Globe. Rotate this handle upward (clockwise) to

lock the Internal Guard in the "open" position (see

figure). The Internal Guard is locked when the handle

snaps into a horizontal position. The waste ports on the

right side of the Globe are now open. Note that the pin

on the opposite side of the globe should be locked

behind the spring as shown below.

Locate Internal

Rotate handle upward

Guard handle

until it locks

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797

www.Litter-Robot.com

Rear View

Pin Locks behind

spring

Press the "Empty" button to move the waste ports to the

discharge position. The Litter-Robot Globe rotates

clockwise to dump the litter into the waste drawer.

Press any button to stop the rotation if you want to

interrupt the Empty cycle. After the litter has dumped

into the waste drawer, you can press any button on the

Control Panel to return the Globe to the home position.

If some litter remains in the Globe, you may want to

sweep the remainder out with a brush.

Cleaning the Globe

After removing all litter from the Globe, clean the Globe

with water and a mild soap. There are no electronic

components in the Globe which can be damaged by

soap and water. If the Globe has become extremely

dirty, it can be soaked or cleaned with a water hose. Be

sure that the Globe is completely dry before returning it

to the Base.

For a quick touchup, you can use a disposable wipe

(such as Lysol or Clorox) to wipe the inside and upper

half of the Globe. This can be done without removing

the litter. The Litter-Robot can be used immediately

after this touch-up because drying is almost

instantaneous.

Cleaning the Waste Drawer

The drawer can easily be removed and cleaned with

soap and water.

Cleaning the Base

Never submerge or soak the Base. The Base

contains the Cat Sensor and electronics. You can wipe

the surfaces of the Base with a cloth dampened with a

disinfectant.

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797