Dynacord DMM 4650 Informasi Teknis - Halaman 11

Jelajahi secara online atau unduh pdf Informasi Teknis untuk Peralatan Musik Dynacord DMM 4650. Dynacord DMM 4650 19 halaman. Signal processor

Halaman Cetak
After showing a short message that
storing was successful, the display
returns to the start-screen of the
sequence.
In case you want to give the new sequence its own name, you have to follow this procedure:
Pressing the indicated cursor key enters the title-menu.
Pressing the soft key "ok" prepares the system for the
entry of a new name.
The following programming steps – entering and saving the desired name - are equivalent to the above
description of how to enter and store the "title of a message" (page 24).
The priority of the new sequence S03 has to be set to a value of 90. Thus, follow these steps:
The priority-menu is entered by pressing the indicated
cursor key three times and pressing the "ok" key
prepares the system for the entering of a new priority
value.
The display shows the programmed priority of the
sequence S27.
Press the indicated cursor key until the required value of
"90" is displayed.
Pressing the "EXIT" button displays the question
"save?". Use the soft key "yes" to save the priority
for the sequence S03.
After showing a short message that the
storing was successful, the display
returns to the priority-screen of the
sequence.
Pressing the "EXIT" key once lets you return to the main
menu. This concludes the programming of your new
procedure.
You want your new sequence to be triggered by pressing the desired button on port B input 4. Thus,
the programming is performed in the "trigger" menu.
Pressing the indicated cursor key enters the trigger
menu. Press the "ok" button to acknowledge your
selection.
The display shows that the input 1 of the port A is
disabled.
Pressing the indicated cursor key selects the port B. In
the bottom line of the display, the setting for port B, input
1 is shown.
Sequence
saved
Naming The Sequence, Title
Priority Of The Sequence
Sequence
saved
Setting The Trigger
Sequence
steplist
Ù
Sequence
Ø
×
Ú
Ù
Sequence
Ø
×
priority
3x
Ú
Sequ priority
Ù
Sequ priority
Ø
×
Ú
Sequ save
EXIT
Sequence
priority
Main-Menu
EXIT
Sequence
Ù
Main-Menu
Ø
×
Ú
starttrg A.1 set
off
Ù
starttrg B.1 set
Ø
×
H >00,1s dyn S23
Ú
ok
title
ok
ok
80
90
y
to S03
n
ok
ok
Trigger
ok