Daytime BC16 Panduan Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pengontrol Daytime BC16. Daytime BC16 12 halaman. Single-channel for matrix

To set the end of the pause, press the S3 button and hold it down until the status LED starts to

blink red. Then press the S1 button to specify the number of hours (e.g. pressing zero times =

00:00 / pressing six times = 06:00). Then release the buttons. The red status LED will then return

to green after a short time; this indicates that normal operations have resumed.

Note: To disable the pause feature, set the start and end of the pause to 00:00. First press S2 until

the status LED illuminates red. Then release S2 (S1 is not pressed, so the time is set to 0:00).

Wait until the status LED is green. Press the S3 button until the status LED illuminates red. Then

release S3 and wait until the LED turn green.

8. Factory settings:

The BC16 has factory default settings and can be reset at any time as follows:

1. Disconnect the power supply.

2. Press and hold both the S2 and S3 buttons.

3. Connect the power supply.

4. The Status LED acknowledges the reset to factory settings by rapidly flashing

red/green.

5. Release buttons S2 and S3.

Stored default settings:

Sunrise start:

Sunset start:

Pause:

Brightness of daylight:

Brightness of night light: 0%

Transition period:

Note: When the factory default settings are loaded, the internal clock is set to 00:00 hours and

must then be correctly set to the real time.

9. Time-lapse function (special mode):

The BC16 has a time-lapse mode that can be used for testing purposes or for checking your

specified values. When it is enabled, the clock runs several times faster and shows the specified

light program in fast motion in 60 seconds. Instead of the standard transition periods used in the

normal operating mode, shorter (only a few seconds) transition times are used. This can be

enabled or disabled during operations. When the time-lapse function is disabled, the clock

resumes running with its previously set time, so that it does not need to be set. You can enable

and disable the time-lapse function as follows:

Press the S1 button briefly five times in succession in order to switch the time-lapse function ON

or OFF.

If the time-lapse function is enabled, the status LED flashes alternately red/green. Buttons S2 and

S3 are disabled in time-lapse mode.

08:00

21:00

Disabled

100%

Stage 3 (5 minutes)