Automatic LPM200 Panduan Operator & Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Operator & Instalasi untuk Peralatan Industri Automatic LPM200. Automatic LPM200 16 halaman. Stationary roller mill
Congratulations! You are now the owner/operator of America's finest roller mill. Please take a few
minutes to be sure that you understand the maintenance and operation of this roller mill. Read this
operator's manual carefully: you'll get better results and have fewer problems.
After your roller mill has been in operation for a few hours, check for loose bolts, setscrews, belts,
etc. All are tight when the roller mill leaves the factory; however, after a break-in period, some items
may require additional tightening. Like any other machine, your Automatic roller mill requires proper
care and intelligence in operation. Misuse and neglect will only cause unnecessary expense and
dissatisfaction.
This manual is written as a guide for owners and operators of the Automatic LPM200 model roller mill.
Read it carefully and follow the suggestions made. Keep this manual in a convenient place for quick,
easy reference, and use it whenever questions arise.
Fill in the following information now for future reference and convenience. Always give this information
to your dealer when ordering new parts. If at any time it becomes necessary for you to write directly
to Automatic Equipment Manufacturing Company for additional information, give the model and serial
number of your machine, and as much descriptive information as possible. It will enable us to more
thoroughly and quickly expedite your order.
Model No. ______________________________
Date of Purchase ________________________
Name and Address of Dealer
Although everything is in working order when the roller mill leaves the factory, some components may
get out of adjustment in transit. The following inspection must be made prior to operation. Check each
item listed and make adjustments if necessary. Refer to the corresponding sections of the manual to
determine the correct settings for individual items.
Check all belts for proper tension and alignment.
•
• Check to make sure the set screws in all pulleys and bearings are tight.
• Check all grease line connections and lines for damage during shipment.
• Make a general check for bolts that may have vibrated loose during shipment.
• Check greased bearings for proper lubrication.
• Check to make sure all shields and guards are in place.
• After operating the roller mill for the first few times, go through this checklist again. Some bolts,
setscrews and belts may require additional adjustment during this break-in period.
405-0525 Rev A
______________________________________________________________
______________________________________________________________
Dealer/Operator Pre-Use Inspection Checklist
Introduction
Serial No._______________________________
Page 2 of 16
4/5/16