Automatic CS184-A Buku Petunjuk - Halaman 10

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Melihat Automatic CS184-A. Automatic CS184-A 16 halaman. 1500w 184mm (7 1/4”)

Halaman Cetak

Note. Always make a trial cut in a scrap piece of material

along a guideline to determine how much you should offset

the blade from the guideline to make an accurate cut.

Switching on and off

1. Connect the plug to the power supply.

2. To turn on, depress the lock-off button (Fig. F) and

squeeze the On/Off trigger switch (Fig. G).

3. The blade will take approximately 2 seconds to reach

full speed.

4. To Turn OFF, release the On/Off trigger switch, the

machine turns off and the lock-off button re-engages to

prevent accidental operation.

CAUTION. Allow the blade to come to a complete standstill

before setting the saw down.

Making a cut

1. Mark the line of cut on the

work piece.

2. Adjust the depth of cut and

bevel angle as required.

3. When making 90° cross or rip

cuts, align your line of cut with

the outer blade guide notch on

the base of the saw (Fig. Ha).

4. When making 45° bevel cuts,

align your line of cut with the

inner blade guide notch on the

base of the saw. (Fig. Hb).

90° Cut

45° Cut

5. Rest the front edge of the

base on the work piece

(Fig. I).

6. Start the motor by depressing

the lock-off button and

squeezing the On/Off trigger

switch.

Note. Always let the blade reach

full speed (approximately

2 seconds) before you begin

to cut into the work piece.

7. Slowly push the saw forward

using both hands (Fig. J).

8. When making a cut always

use steady, even pressure.

Forcing the saw causes rough

cuts and could shorten the life

of the saw or cause kickback.

Allow the blade and the saw

to do the work.

9. After completing your cut, release the trigger switch

and allow the blade to come to a complete stop.

Do not remove the saw from the work piece while

the blade is moving.

Note. Since blade thickness varies, always make a trial

cut in scrap material along the guideline to determine how

much, if any, the guideline must be offset to get an

accurate cut for the job being performed.