Celect DRF4 Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Termostat Celect DRF4. Celect DRF4 8 halaman. Rf programmable thermostat for weekday/weekend setting

Halaman Cetak

F. Set Program:

1. Press <PRG>, the hour will flash, press < >, < > to

change the hour setting.

2. Press <PRG>, the minutes will flash, press < >, < >

to change the minutes setting.

3. Press <PRG>, temperature will flash, press < >, < >

to change the setpoint.

4. Press <PRG> to set the next program.

5. The program setting sequence is as below:

Mon~Fri (P1

P4 P5 P6)

P4 P5 P6) ...

6. Press <

> to exit the program setting mode and

return to the normal mode.

Or transmitter will auto-return to normal mode after 10

seconds.

G. Temporary / Permanent Override Mode:

1. There are two modes in the override mode (Temporary

override and Permanent override mode).

The sequence is as below:

P4 P5 P6)

Sat (P1

Sun (P1

"Reset" if necessary.

B. Start/Reset:

1. After wiring and mounting, switch off all the connected

devices. Place 2 new AAA 1.5V alkaline batteries

according to the polarities marked.

LCD display will be switched on.

2. Press 'RST' to reset. The DRF4 will be ready to control

the heater / cooler.

3. Switch ON the heater/cooler and receiver. The

heater/cooler will remain OFF until transmitter activates

the output ON with

C. Normal Time Mode:

1. Temperature detection starts and LCD displays the

room temperature.

2.If Battery is LOW,

batteries must be replaced with new one immediately.

3. Defrost function is activated with

temperature is 5° C or below. Output will be forced to

ON @ Heat & OFF @ Cool.

displayed on LCD.

will be flashing. The old

displayed when