Daytona DS300LR Panduan Pemilik & Petunjuk Keselamatan - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Pemilik & Petunjuk Keselamatan untuk Jacks Daytona DS300LR. Daytona DS300LR 13 halaman. 3 ton heavy duty low profile long reach floor jac
Halaman CetakIMPORTANT SAFETY INFORMATION
1. Study, understand, and follow all instructions
before operating this device.
2. Do not exceed rated capacity.
3. Use only on a hard, level surface
capable of supporting the load.
4. Support the vehicle with appropriate
means immediately after lifting.
5. Failure to heed these markings may result in
personal injury and/or property damage.
6. Lift only on areas of the vehicle as
specified by the vehicle manufacturer.
7. No alterations shall be made to this product.
8. Only attachments and/or adapters supplied
by the manufacturer shall be used.
9. Do not move or dolly the vehicle while on the jack.
10. Never work on, under or around a load
supported only by this device.
11. Do not adjust safety valve.
12. Wear ANSI-approved safety goggles and
heavy-duty work gloves during use.
IMPORTANT! Before first use:
Check hydraulic oil level and fill as needed as stated on page 6. Thoroughly test the Jack for proper
operation. If it does not work properly, bleed air from its hydraulic system as stated on page 6.
Page 2
SAVE THESE INSTRUCTIONS.
For technical questions, please call 1-888-866-5797.
13. Keep clear of load while lifting and lowering.
14. Lower load slowly.
15. Apply parking brake and chock tires
before lifting vehicle.
16. Inspect before every use; do not use if parts are
loose or damaged, or if leaking hydraulic fluid.
17. Do not use for aircraft purposes.
18. Do not use any objects (such as blocks of wood) in
between Saddle Pad or Saddle and lifting point.
Objects placed on the Saddle will reduce
the stability of the Jack, and could allow the
vehicle to slip off the Saddle and fall.
19. The warnings, precautions, and instructions
discussed in this manual cannot cover all
possible conditions and situations that may occur.
The operator must understand that common sense
and caution are factors, which cannot be built into
this product, but must be supplied by the operator.
20. CAUTION! The Handle Socket will be held
down by a plastic block under tension. Wear
ANSI-approved safety goggles before freeing
Handle Socket. Hold Handle Socket down while
removing block. After removal, carefully swing
Handle Socket up until tension is released.
Floor Jack