Daytona DS300LR Panduan Pemilik & Petunjuk Keselamatan - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemilik & Petunjuk Keselamatan untuk Jacks Daytona DS300LR. Daytona DS300LR 13 halaman. 3 ton heavy duty low profile long reach floor jac

Halaman Cetak

Operation

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this

manual including all text under subheadings therein before set up or use of this product.

Lifting

Park vehicle on a flat, level, solid, surface safely away from oncoming traffic. Turn off the vehicle's engine.

Place the vehicle's transmission in "PARK" (if automatic) or in its lowest gear (if manual).

Set the vehicle's emergency brake. Then, chock the wheels that are not being lifted.

1. Turn the Handle counterclockwise to lower the Jack.

Once the Jack is fully lowered, turn the

Handle firmly clockwise to close it.

2. Carefully position the Saddle of the Jack under the

vehicle manufacturer's recommended lifting point.

(See vehicle manufacturer's owner's manual

for location of frame lifting point.)

3. Step on Foot Pedal until the top of the Jack's Saddle

has nearly reached the vehicle lifting point. Position

the Saddle directly under the vehicle's lifting point.

4. To lift the vehicle, pump the Handle.

Use smooth, full strokes.

5. Once the vehicle is raised, slide a jack stand of

appropriate capacity (not included) under a proper

lifting point referred to in the vehicle owner's

manual. Always use two jack stands, position them

at the same point on each side of the vehicle.

Lowering

1. Carefully remove all tools, parts, etc.

from under the vehicle.

2. Position the Saddle under the lifting point.

Turn the Handle firmly clockwise and raise

load high enough to clear the jack stands,

then carefully remove jack stands.

Floor Jack

For technical questions, please call 1-888-866-5797.

WARNING! The rated capacity of jack stands is per

pair, not the individual capacities combined unless

specifically noted on the product by the jack stand

manufacturer. Do not exceed rated jack stand

capacity. Ensure that the vehicle support points

are fully seated in the saddle of both jack stands.

Use a matched pair of jack stands per vehicle to

support one end only. Failure to do so may result

in the load suddenly falling, which may cause

personal serious injury and/or property damage.

6. Center saddle of the jack stand(s) under the vehicle's

lifting point(s). Set the jack stand(s) to the same

height according to the manufacturer's instructions,

making sure that they lock securely into position.

7. Slowly turn the Handle counterclockwise to lower

the vehicle onto the saddle(s) of the jack stand(s).

Then, turn the Handle firmly clockwise to close it.

3. Slowly turn the Handle counterclockwise

(never more than 1/2 full turn) to lower

the vehicle onto the ground.

4. Lower the Jack completely. Then, store in a

safe, dry location out of reach of children.

Page 7