Automatic WTLD018 Buku Petunjuk - Halaman 8

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Bor Automatic WTLD018. Automatic WTLD018 16 halaman. 20v drill/driver

Halaman Cetak

electricity is generated nor let the battery touch something

that is statically charged.

• The battery can be stored at temperatures between

0 - 40° C.

NEVER STORE OR LEAVE YOUR LITHIUM ION

BATTERY IN TEMPERATURES OVER THAT

RECOMMENDED OTHERWISE FIRE MAY OCCUR.

Do NOT store the Lithium Ion battery anywhere that

the temperature can easily reach higher temperatures

than recommended - this includes garden type sheds,

and Vehicles where the inside temperature can climb

to dangerous levels in the direct sunlight and on high

temperature days. THINK BEFORE LEAVING YOUR

LITHIUM ION BATTERY PACK IN STORAGE.

• The battery can be charged or operated at temperatures

between 0° C and 40° C.

NEVER CHARGE YOU LITHIUM ION BATTERY BELOW

OR ABOVE TEMPERATURES RECOMMENDED

OTHERWISE FIRE OR SERIOUS DAMAGE TO THE

BATTERY PACK MAY OCCUR.

The most suitable temperatures to charge the battery pack

are between 20 - 25° C.

• Always allow the battery pack to cool down after

charging, do not place it in a hot environment such as a

metal shed or open trailer left in the sun.

• Take care where the tool is stored. Do not store in areas

of corrosive fumes, or salt air or similar conditions. Try

and store the tool in the packaging supplied with the tool.

• Do not dispose of the battery in a fire or put the battery

into a microwave oven, conventional oven, dryer, or high-

pressure container.

Under these conditions, the battery may explode.

• Never attempt to open the battery pack, puncture the

battery or subject the battery to strong physical shock.

• If the plastic housing of the battery pack breaks open

or cracks, immediately discontinue its use and do not

recharge it. Ensure the battery pack clip is in good

condition and will not allow the pack to fall free from the

tool. If the clip is damaged or for any reason is not locking

the pack in place Do Not continue to use.

• Stop using the battery if it exhibits abnormal heat, odour,

colour, deformation, or is in an abnormal condition.

• If you detect leakage or a foul odour, it is especially

important to keep the battery away from fire. If battery

liquid leaks onto your skin or clothes, wash well with

clean water immediately. If liquid leaking from the

battery gets into your eyes, do not rub your eyes.

Rinse your eyes well (for at least 10 minutes) with clean

water, and consult a doctor immediately. Do not use a

leaking battery.

• Handle batteries with care to avoid shorting the battery

with conducting materials, such as nails, screws, metal

watch bands, rings, bracelets, and keys. The battery may

overheat and could burn you.

• After the battery has reached the end of its useful life,

we recommend recycling the materials at your local

municipal council recycling centre. DO NOT attempt to

replace the battery cells in the battery pack, repair or

modify any part of the battery pack assembly

• When recycling, make it nonconductive by applying

insulating tape to the terminals located on the battery.

When to charge the battery

New battery packs are shipped in a low charge

condition and must be fully charged before use. It takes

approximately 8 hours to fully charge a new battery and

3-5 hours once the battery has been used in the tool

a few times.

Charging of batteries should not be undertaken casually.

Through the charging cycle the condition of the battery pack

should be monitored and the charge cycle turned

off at completion or at the end of the recommended time.