HIBLOW hp-150 Buku Petunjuk - Halaman 4
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pompa Air HIBLOW hp-150. HIBLOW hp-150 13 halaman. Air pumps
Juga untuk HIBLOW hp-150: Manual (8 halaman), Buku Petunjuk (17 halaman)
Halaman Cetak
EXTENSION CORDS
Use only a 3-wire extension cord that has a 3-blade grounding plug, and a 3-slot receptacle that will
accept the plug on the product. Make sure your extension cord is in good condition. When using an
extension cord, be sure to use one heavy enough to carry the current that your product will draw.
A cord no longer than 100 feet, No.16 AWG extension cord should be used. An undersized cord will
cause a drop in line voltage resulting in loss of power and overheating. For outdoor use, use an
extension cord that is approved for outdoor use, marked W-or W-A.
MOUNTING
CAUTION:
When using the pump to inject air into a liquid, make sure that the pump is higher
than the surface level of the liquid, otherwise that liquid may run back into the
pump if the power is interrupted.
The pump should be in an upright, level position and remain on a stable, rigid operating surface for
proper operation.
PLUMBING
Improper connection will cause leakage of air.
HP Series : Connect the pumps exhaust port and PVC(plastic)pipe with an L-shaped rubber hose.
Be sure to secure place of connection with a hose tightening clip(Refer to Fig.1).
Fig. 1
STORAGE
Store indoors out of the weather in a dry area. Make certain the electrical cord is placed so there will
be no chance of damage.
CAUTION:
To avoid risk of electrocution or damage to the pump do not store this unit where it
could come into contact with water or other liquids. Store indoors. Inspect
compressor and cord for damage prior to putting compressor back into service.
3
Pump's exhaust port
L-shaped rubber hose
Hose tightening clip
PVC
(Plastic) pipe