EmergoPlus EM010001NL Panduan Pengguna - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Kamera EmergoPlus EM010001NL. EmergoPlus EM010001NL 17 halaman. Lifepo4 battery

Connect the negative pole of the battery to the negative connection of the caravan mover unit.

Connect the positive terminal of the battery to the positive terminal of the caravan mover unit.

Use cables as prescribed in your caravan mover manual. It is recommended to use a minimum of 16 mm².

Use one red wire for the + and one black or blue wire for the -.

Never connect the battery in parallel to any other type of battery, including the wiring from the car.

Do not work on the LiFePO4 battery or the installation when it is still live. Only make changes to your electrical

installation carried out by qualified electricians.

After first use test all the connections for (over) heating. Repair or replace connections that have become

too hot.

Check the wiring and connections at least once a year. Immediately rectify defects such as loose

connections and burnt/melted cables.

System overview:

Figure 3. Wiring diagram

CAFEFUL!

Observe the polarity of the battery and avoid short

circuits! Equipment whose polarity is incorrectly

connected can be irreparably damaged.

PAY ATTENTION!

Install a fuse and a main switch to the

power

circuit

according

regulations. Place the fuse as close as

possible to the + pole of the battery.

DOCUMENT: E09-X20&X30 V2.0-EN03_Handleiding

CAREFUL!

If bolts which are too long are used, the

connections will not get tight! This leads to

large contact resistances and can cause the

battery or equipment to spark or switch off.

local

WARNING!

Never connect the battery in parallel to another

battery, including the wiring from the car.

An X20 can be connected in parallel with another X20 battery.

Page 11 of 16

A = PowerXtreme X20/X30

B = Fuse

C = Main switch

D = Load

Date: 10-2-2021