Dynacut MDM Panduan Pengoperasian - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sistem pelumasan Dynacut MDM. Dynacut MDM 17 halaman. Minimum quantity lubrication system for external lubrication
Halaman Cetak
The DYNACUT-MDM minimum quantity lubrication system can be used both for the initial
equipment of processing machines and for the retrofitting of processing machines with an
existing cooling lubricant supply.
Any other use or use beyond this is considered to be improper. Dynacut UG is not liable for
damages resulting from this.
The lubricants suitable for use in DYNACUT minimal-quantity lubrication systems for external
lubrication are specially adapted to the high requirements of the technology used in their
chemical and physical properties.
For this reason lubricants suitable for minimum quantity lubrication may be used.
We cannot assume any liability for damage caused by improper use of lubricants or by the use
of lubricants suitable for minimum quantity lubrication.
Safety instructions
Please observe the following safety instructions in order to ensure the trouble-free
functioning of the minimum quantity lubrication system and to avoid damage.
Spraying of lubricants or substances which are released for minimum quantity lubrication
with DYNACUT minimum quantity lubrication systems is not permissible.
Prior to any work on the system, e.g. cleaning or replenishing lubricant, etc., the system must
be disconnected from the compressed air supply and depressurized.
Humans or animals must not be aerosolized. The aerosol must not get into the eyes and should
not be inhaled directly.
We point out that the spraying of mineral oils or mineral oil-containing substances can lead to
health damage.
Any kind of fire e.g. in the form of open flames, sparks, glowing cigarettes, etc., must not get
into the vicinity of the spray jet. The aerosol must not be sprayed on hot surfaces.
The generally valid rules and safety regulations for the work with compressed air and electrical
voltage carrying machinery and equipment must be observed.
The system may only be used in a technically perfect condition as well as in accordance with
its intended purpose, in accordance with safety and driving safety, observing the operating
instructions.
The existing safety devices must not be damaged, immobilized or rendered unusable or
replaced by parts other than those expressly approved by Dynacut UG.