GAI-Tronics 12576-502 Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Telepon GAI-Tronics 12576-502. GAI-Tronics 12576-502 13 halaman. Desktop access panels

Halaman Cetak

Model 12576-502 & 12576-50215 Desktop Access Panels

Page Timeout – This sets amount of time the access panel can generate a page. If the limit is exceeded,

the page will cease and a busy tone is heard in the handset receiver. A trouble report will be sent to the

control cabinet. If the handset page switch is released, the page timer is reset. The page timeout can be

disabled or set for 1–25 minutes in 1-minute intervals.

: By default, the page time-out for access panels is disabled.

OTE

Off-Hook Timeout – This sets amount of time the access panel can be in use or off-hook. If the limit is

exceeded, handset operation will cease and the access panel will be placed electrically on-hook. A

trouble report is sent to the control cabinet. The handset remains inoperative until it is physically placed

back on-hook. The off-hook timeout can be disabled or set from 1–25 minutes in 1-minute intervals.

: By default the off-hook time-out for access panels is disabled.

OTE

Handset Paging Pre-announcement Tones

An access panel page can be preceded by one of two available tones. Tone selection is based on the

system mode of operation at the time of the page (normal or alarm). The "Splash" is a Hi-Lo tone

approximately 1 second in duration. The "Alert" is a swept tone approximately 1 second in duration.

: By default, the splash tone is enabled.

OTE

Activating an Alarm

Activate an alarm from the access panel as follows:

1. Select the desired destination using the zone push button(s) if configured. The destination could be a

single zone, a group of zones, or all zones. The LEDs of the selected zone switches illuminate.

2. Select the appropriate alarm push button. The alarm broadcasts into the selected zones, and the LED

of the selected alarm illuminates during the broadcast.

3. For access panels equipped with an E

the alarm push button to activate the alarm in the selected zones.

OTES

1. To cancel any concurrent alarm, press the C

button. This cancels all alarms that are currently playing or that are in the alarm queue.

2. Alarms may also be configured to play immediately when the alarm push button is pressed. In this

case a zone selection is not required. The alarm's destination is pre-configured in the system

programming.

Sonalert

The sonalert is an audible indicator and its control signal is paralleled with LED output #20. It is

typically configured to sound when the access panel loses communication with the ADVANCE System

control cabinet.

Lamp Test Feature

The lamp test feature is used to verify that the access panel indicators are functioning properly. When the

push button is pressed, the switch indicators illuminate, and the panel sonalert will sound.

AMP

EST

: The L

push-button does not include an indicator.

OTE

AMP

EST

e:\standard ioms - current release\42004 instr. manuals\42004-732l2c.doc

07/14

push button: Press the E

NTER

push button or the R

ANCEL

URRENT

Pub. 42004-732L2C

Page 9 of 11

push button after pressing

NTER

push

ESET