DaytonAudio SUB-800 Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Subwoofer DaytonAudio SUB-800. DaytonAudio SUB-800 4 halaman. 8" 80w powered subwoofer

Thank you for purchasing the Dayton Audio

is the perfect addition to any home theater system. This powered sub features a

bottom ﬁring ﬂared port bass reﬂex design for reduced port noise and increased

bass response. It also utilizes a long throw 8" woofer and up to 80 watts of house

shaking power. This compact sub is ﬁnished in a non-obtrusive black veneer that will

complement any decor.

Hookup

1. Line Level Inputs

The line level inputs are used to connect pre-out or preampliﬁer outputs directly

to the subwoofer ampliﬁer's internal crossover. These inputs are summed to

mono. This is the preferred way to connect the subwoofer ampliﬁer. If you

have a mono line level signal from a "Pro Logic"or "Dolby Digital" receiver

use the right "red" input. Note: If a LFE mono output is connected, set the

crossover point to maximum.

2. High Level Inputs

If preampliﬁer outputs are not available, use the high-level (speaker) inputs. The

speaker level inputs can be connected directly to the ampliﬁer by inserting the

speaker wire.

3. High Level Outputs

There are also high level outputs which can be used to connect to main speakers

or to another powered subwoofer with high level inputs. Note: High level

outputs are paralleled to the high level inputs with no high pass ﬁlter.

4. Crossover Frequency Control:

Continuously variable from 40 Hz to 140 Hz at 12 dB/octave. Set the frequency

control to where the audio does not sound "muddy", normally between 60-80 Hz.

Note: If a LFE mono output is connected set the crossover point to maximum.

5. Gain Control:

Adjusts the output level of the subwoofer. Set the level to where the bass

frequencies blend with the other speakers. Note: Most people have a tendency

to set the level too high, which makes the audio sound "boomy".

6. Phase Switch:

Selectable between 0° and 180°. This assists subwoofer placement. The

correct position will be the one that provides the most apparent bass output.

7. Power Switch (Auto On/Off):

When the power is in the auto position, the ampliﬁer will automatically turn on

when a signal is present. Note: In auto/off mode, the power on LED is always on

(red), even when amp is in rest mode (off). The power LED will turn green when

the unit is activated.

SUB-800 8" Powered Subwoofer. It