Hiboy TITAN Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Skuter Hiboy TITAN. Hiboy TITAN 11 halaman.
Juga untuk Hiboy TITAN: Panduan Pengguna (11 halaman)

Halaman Cetak

4. Put the handlebar on it and tighten the screws

5. Remove the rear screws, install the rear fender then tighten the screws

5. Riding Basics

Preparation for riding

Prepare the product according to the instructions. Always wear a helmet and safety gear so to

avoid falling and injury during the driving learning, as shown in the figure. Keep away from

vehicles and crowded areas.

Riding

1.Use the key to start the scooter

2.Click the power button to start your scooter

3.Click "▲" and "▼"button to adjust Speed Mode( Mode1(ECO), Mode2(STD),

Mode3(TURBO))

4.Step on the deck of scooter and propel yourself, then press throttle lever to ride your scooter.

Note: When the scooter stops driving and the meter is not operated for 3 minutes, the

dashboard and the scooter will turn off. (The shutdown time can be set)

Handlebar Operation Instructions

1.Press the yellow button to turn on the light.

2.Press the red button to switch single or dual motor. (Default is single motor, press button to

switch dual motor)

3.Use your left hand to operate the rear brake.

4.Use your right hand to operate the front brake.

Cruise Control Operation Instructions

Long press "▼" to enter the cruise control. When riding at a constant speed for 8 seconds,

cruise control starts, braking, or accelerating can end cruise control, and long press "▼" again

to exit cruise control