Dynaflow MK5 Eco Manual - Halaman 2

Jelajahi secara online atau unduh pdf Manual untuk Panel Kontrol Dynaflow MK5 Eco. Dynaflow MK5 Eco 8 halaman.

Additional Equipment

1. Interface Card

a. Provide the interface to the P5 Control Panel.

b. Alarm inputs and outputs.

c. Battery backup.

2. BMS Card

a. This card is an "option" that is used to provide LOW Level interface to Building

Management Systems.

b. Outputs: Start/ Stop, Low Air Fault, Emergency Isolator Activated, Power Failure and low

scrubber level.

Display

Display functions

 Time and date display

 Cupboard serial number and firmware version number.

 Operating mode and current status display.

Status and alternate switch function display

Keypad

There are 4 primary push buttons on the front with a 5

operation they control lighting, cupboard start and stop, Syncroflow® and buzzer mute.

Together with the function button they have alternate functions that are used to setup and

configure the fume cupboard.

Light

Control's the cupboard lighting. Toggle function, press to turn on, and press to turn off.

Will operates in any of the cupboard's operational modes.

Fan

Control's the cupboard operational modes. Toggle function, press to start cupboard. Starts 60

Second "PRE-PURGE" mode. When in "RUNNING" mode press again to shut down cupboard and

commence 20 minute "POST-PURGE" mode.

Boost

Control's cupboard Syncroflow® mode when fitted. When pressed allows fan boost of fume

cupboard extraction. When Syncroflow not fitted button will have no effect.

Mute

Allows the user to mute the alarm tones when the cupboard signals an alarm condition. When

pressed the mute, shall remain in effect until the alarm condition has been corrected or a new alarm

state is entered.

function button. During normal