AFG 4.0AH Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sepeda Latihan AFG 4.0AH. AFG 4.0AH 17 halaman. Recumbent

Halaman Cetak
AS SE MB LY ST EP 2
BOLTS (B)
SEAT SLIDE
PRE-ATTACHED
ADJUSTMENT LEVER SCREW
3.0AR SHOWN
A.
Open hardware bag for step 2.
B.
Firmly Tighten the pre-attaChed adJustMent LeVer sCrew to the braCKet.
C.
Attach the seat fraMe to the seat sLIde using 4 boLts (b).
D.
Attach the puLse grIp wIres from the rear of the recumbent to the puLse grIp wIres from the
puLse grIp bar.
E.
Press CoVered puLse grIp wIres into the pLastIC CLIp as shown above. Tuck eXposed wIres into
reCess under puLse grIp bar.
PULSE GRIP BAR
F.
Attach the puLse grIp bar to the seat sLIde using 4 boLts (b).
BOLTS (B)
Note: Tuck in wires as shown. Be sure that the puLse grIp wIres will not be crushed when adjusting the
seat back and forth.
HARDWARE BAG FOR STEP 2 CONTENTS :
2.0_3.0_AR_Rev.2.3.indd 8-9
PULSE GRIP BAR
BOLTS (B)
3.0AR SHOWN
BOLT (B)
10 mm
Qty: 8
ASSEMBLY STEP 3
SEAT BASE
SEAT BACK
SEAT FRAME
WASHERS (D)
WASHERS (D)
BOLTS (C)
3.0AR SHOWN
A.
Open hardware bag for step 3.
B.
Attach seat base to seat fraMe using 4 boLts (C) and 4 washers (d).
C.
Attach seat baCK to seat fraMe using 4 boLts (C) and 4 washers (d).
SEAT BACK
HARDWARE BAG FOR STEP 3 CONTENTS :
BOLT (C)
40 mm
WASHERS (D)
Qty: 8
BOLTS (C)
BOLTS (C)
3.0AR SHOWN
WASHER (D)
17 mm
Qty: 8
8/1/07 11:41:57 AM