GAI-Tronics Clean Phone 295W Manual - Halaman 5
Jelajahi secara online atau unduh pdf Manual untuk Telepon GAI-Tronics Clean Phone 295W. GAI-Tronics Clean Phone 295W 19 halaman.
Halaman Cetak
- 1. General Information
- 2. Safety Guidelines
- 3. Installation
- 4. Programming Information
- 5. Local Programming
- 6. Remote Programming
- 7. Programming Instructions
- 8. Programming Table
- 9. Incoming Calls
- 10. Outgoing Calls
- 11. Operating Instructions
- 12. User Instructions
- 13. Specifications
- 14. Replacement Parts
- 15. Warranty
- 16. Return Policy
Model 295F and 295W Clean Phone™ Telephone
Model 295W Mounting and Wiring
1. Position the back box on the wall, making sure the box is level. Drill the two corner holes in the
upper left and lower right, and secure it with the screws.
2. Drill the remaining holes, and secure the remaining screws.
3. Feed the wires through the bushing.
4. Snap the cover off the modular wall jack. Refer to Figure 3. Wire the incoming tip wire to the green
wire in the modular jack, the incoming ring wire to the red wire in the modular jack, the (COM) wire
to the yellow wire, and the (-48 V) wire to the black wire. DO NOT REMOVE the blue and white
wires. Replace the modular wall jack cover.
5. Plug the modular connector from the front panel assembly into the modular wall jack.
6. Take the front panel of the clean telephone and align it with the four slots in the mounting bracket.
7. Using the pressure point shown in Figure 2, push the panel firmly in and then down.
d:\standard ioms - current release\42004 instr. manuals\42004-146h.doc
11/05
Figure 3. Mounting the Model 295W
Pub. 42004-146H
5 of 17
Page: