Greatneck 80161 Panduan Pemilik - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Melihat Greatneck 80161. Greatneck 80161 18 halaman. High speed circular saw

Halaman Cetak

Do not overreach. Keep proper footing

and balance at all times. Proper footing

and balance enables better control of the

tool in unexpected situations.

Use safety equipment. Always wear eye

protection. Dust mask, non-skid safety

shoes, hard hat or hearing protection must

be used under applicable conditions.

TOOL USE AND CARE

Use clamps or other practical method to

secure and support the workpiece on a

stable platform. Holding the work by hand

or against your body is unsafe and may

lead to loss of control.

Do not force the tool. Use the correct

tool for your application. The correct tool

will do the job better and safer at the rate

for which it is designed.

Do not use the tool if the switch does

not turn it ON or OFF. Any tool that cannot

be controlled with the switch is dangerous

and must be repaired.

Disconnect the plug from the power

source before making any adjustments,

changing accessories or storing the

tool. Such preventive safety measures

reduce the risk of starting the tool

accidentally.

Store idle tools out of reach of children

and other untrained persons. Tools are

dangerous in the hands of untrained users.

Maintain tools with care. Keep cutting

tools sharp and clean. Properly

maintained cutting tools with sharp cutting

edges are less likely to bind and are easier

to control.

POWER TOOL SAFETY

SAVE THESE INSTRUCTIONS FOR REFERENCE

Check for misalignment or binding of

moving parts, breakage of parts and any

other condition that may affect the tool's

operation. If damaged, have the tool

serviced before using. Many accidents

are caused by poorly maintained tools.

Use only accessories that are

recommended by the manufacturer for

your model. Accessories that may be

suitable for one tool may become

hazardous when used on another tool.

SERVICE

Tool service must be performed only by

qualified personnel. Service or

maintenance performed by unqualified

personnel could result in risk of injury.

When servicing a tool, use only identical

replacement parts. Follow instructions

in the Maintenance section of this

manual. Use of unauthorized parts or

failure to follow Maintenance instructions

may create a risk of electric shock or injury.

SPECIFIC SAFETY RULES

WARNING:

plug in your circular saw until you have

carefully read and understood this

Owner's Manual.

ALWAYS WEAR EYE PROTECTION

THAT CONFORMS WITH CSA

REQUIREMENTS or ANSI SAFETY

STANDARD Z87.1

FLYING DEBRIS can cause permanent eye

damage. Prescription

eyeglasses ARE NOT a

replacement for proper eye

protection.

For your safety, do not