Automatic Technology GDO-11V3 Ero Panduan Pemilik - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pembuka Pintu Garasi Automatic Technology GDO-11V3 Ero. Automatic Technology GDO-11V3 Ero 20 halaman. Overhead garage door opener
Halaman Cetak
12
GDO-11V3 Ero
9. Troubleshooting Guide
Symptom
The door stops or moves
very slowly
The opener does
not work from the
transmitter
The chain moves but the
door remains stationary
Motor is running but
chain is not moving
The transmitter range
varies or is restricted
The door reverses for no
apparent reason
The door opens but will
not close
TM
Home Owner's Manual
Possible cause
Garage door in poor condition e.g.
springs may be broken
The opener does not have power
The battery in the transmitter is flat
Transmitter does not contain
TrioCode
128 Technology
TM
The opener has been put into
"Vacation Mode"
The transmitter button is not
programmed to operate the door.
Door Code LED is flashing yet the
opener is not working.
The opener is disengaged
Damage motor assembly
Variations are normal depending
on conditions e.g. temperature or
external interference
The battery life is exhausted
Position of the transmitter in the
motor vehicle
This may occur occasionally from
environmental conditions such as
areas that are windy, dusty or have
extreme temperature changes.
If Safety beams are installed they
may be partially obstructed.
Safety Beam (Optional Accessory)
not operating correctly
Remedy
Check the door's operation - see
monthly maintenance (Section 10.1)
Plug a device of similar voltage
(e.g. a hairdryer) into the power
point and check that it is OK
Replace the battery (Section 11)
Check that the transmitter has grey
buttons and the model number
on the back displays V2. Contact
dealer for support if otherwise.
Turn off "Vacation Mode"
(Section 8.2, step e)
See coding transmitter procedure
(Section 8.1)
Ensure the correct button on the
transmitter is being pressed.
Re-engage the opener
(Section 6.4)
Contact your dealer for support.
See instructions for correct use of
transmitter (Section 4)
Refer to battery status (Fig 11.2)
Change the position (Section 4)
Put the door into manual (Section
6.1, take note of the CAUTION) and
contact your dealer.
Ensure the beam path is not
obstructed. If continues, contact
your dealer.
Contact your dealer for support