ADEMCO VISTA-50PUL Panduan Tambahan Instalasi - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Tambahan Instalasi untuk Sistem Keamanan ADEMCO VISTA-50PUL. ADEMCO VISTA-50PUL 16 halaman. E2 zone programming
Halaman Cetak
XMIT TO CONFIRM
PRESS
TO SKIP
Entd A022-4063 2
Rcvd A022-4064 2
To Delete a Serial No
Zn ZT P RC In L
10 03 1 10 RF 1s
ENTER ZONE No.
(00 = QUIT)
11
)ROORZLQJ WKH VXFFHVVIXO HQUROOPHQW RI HDFK ZLUHOHVV GHYLFH UHPRYH 21( RI WKH VHULDO
QXPEHU ODEHOV IURP WKH GHYLFH DQG DIIL[ LW LQ WKH DSSURSULDWH FROXPQ RQ WKH ZRUNVKHHWV
SURYLGHG ZRUNVKHHWV VWDUW RQ SDJH WKHQ HQWHU WKH RWKHU LQIRUPDWLRQ ]RQH QXPEHU ORRS
QXPEHU ]RQH W\SH HWF UHOHYDQW WR WKDW GHYLFH
When you have finished programming all zones, test each using the system's Test mode. Do not use the
Transmitter ID Sniffer Mode for this, as it will only check for transmission of one zone on a particular
transmitter. It will NOT check the zones assigned to each additional loop, and will not verify polling loop
type zones.
9. Confirmation Option: This prompt will only appear if you answered
"Yes" in step 1.
The system will enter a confirmation mode so that the operation of the
actual programmed input can be confirmed. Activate the loop input or
button that corresponds to this zone.
If the serial number/loop number combination transmitted does
not match the serial number entered, a display similar to the one at the
left will appear.
If so, activate the loop input or button on the transmitter once again. If
a match is not obtained (i.e., summary display does not appear), press
the [#] key twice and then enter or transmit the correct serial number
again.
To delete an existing serial number, enter "0" in the loop number field.
The serial number will change to "0"s.
10 INPUT S/N:
If "0" was entered in error, simply re-enter the loop number or press [#],
and the serial number will return to the display. Otherwise, press [ ] to
accept.
If the serial number transmitted does match the serial number
entered, the keypad will beep 3 times and a summary display will
appear, showing that zone's programming. Note that an "s" indicates
that a transmitter's serial number has been enrolled.
Press [ ] to accept the zone information.
10. The system will return you to the "ENTER ZN No." prompt for the next
zone.
When all zones have been programmed, enter "00" to quit.
4
L
A 0 0 0 - 0 0 0
0