Automatic Technology HiRO GDO-12 Petunjuk Pengkabelan dan Instalasi - Halaman 4
Jelajahi secara online atau unduh pdf Petunjuk Pengkabelan dan Instalasi untuk Sistem pembukaan pintu Automatic Technology HiRO GDO-12. Automatic Technology HiRO GDO-12 4 halaman. Safety beam kits
Halaman Cetak
Troubleshooting
Symptom
Base station and receiver LED's constantly on
Receiver LED constantly on but cannot close
the door
Receiver LED is blinking and can not close
the door
During optical alignment transmitter LED
stopped working
During optical alignment receiver LED
stopped working
Wireless PE beam works ok but LED's on
receiver and transmitter stopped working
LED on the receiver/transmitter started to
flash during operation of the door
Specifications
Technical Specifications
Infrared beam range
RF link range
RF link frequency
Batteries for Wireless RX and TX
Battery Life
Maintenance
To ensure a long and trouble free life for your Safety Beams, the following is recommended:
a. Periodically test the Safety Beam is operating efficiently by obstructing either the transmitter or receiver during the openers
operation to ensure the door stops.
b. If the Safety Beams are located in a very dusty / dirty environment make sure to clean transmitter and receiver lenses for
optimal performance.
c. Replace batteries in transmitter or receiver (Wireless WPE-2V1 only) when they start to flash during operation of the door.
Warranty
WPE-2V1 & PE-3V1
ACCESSORIES
1 year
© March 2019 Automatic Technology (Australia) Pty Ltd. All rights
reserved. No part of this document may be reproduced without prior
permission. In an ongoing commitment to product quality we reserve
the right to change specification without notice. E&OE.
Possible cause
Receiver is not coded into base station
Receiver not coded into base station
Mains power is not switched on to the opener
Receiver and transmitters not aligned
properly
Beam is obstructed
Setup timed out
Setup timed out
To save battery power LED on transmitter
turns off after number of cycles
The battery in the receiver/transmitter is
getting flat
EasyBeam
TM
20m
This warranty is to be read in conjunction with the owner's copy of the opener installation instruction.
Wireless
6m
-
10m
-
2.4 Ghz ISM Band
-
C-Type x 2
-
3 years approx.
Remedy
Code the receiver into base station
Code the receiver into base station.
Switch on mains power
Realign receiver and the transmitter
Remove obstruction from the path of the
beam.
Press reset button on the transmitter.
Press reset button on the base station.
No remedy required.
Replace the batteries.