Automatic Technology Smart Phone Control Kit Petunjuk Instalasi - Halaman 3
Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Beralih Automatic Technology Smart Phone Control Kit. Automatic Technology Smart Phone Control Kit 4 halaman. Smart hub
Halaman Cetak
Sectional Door Opener Set Up
GDO-9V2, GDO-9V3 and GDO-11
6
Back cover screw
GDO-11
Grommet
Network /
Programmer Pin
Smart Phone Control Kit Installation Instructions
7
Grommet
Network /
Programmer Pin
Preparation of Opener
a. Disconnect the power supply to the opener.
b. Remove the cover or back cover via screw at top.
c. Remove the grommet out of the chassis.
d. Cut (1) one side of the grommet with a knife or scissors.
e. Slide the network timing harness
f. Refit grommet to chassis by sliding the harness through hole
before fitting grommet.
g. Connect the harness to the network / programmer pin on the
control board.
h. Refit the cover.
Mount and connect Transceiver
a. Plug the other end of the harness into the transceiver
b. Using the velcro
opener as shown.
WARNING: DO NOT drill into the chassis or covers. No
screws are required to secure the transceiver.
Re-setup and Test the Opener
a. Reconnect power and remove the button cover.
b. Setting Limits:
i. If limits have not been set, follow the openers installation sheet
to set limits.
ii. If limits were set previously, clear limits and follow openers
installation sheet to set limits.
c. Refer to the Smart Phone Control Kit User Guide to set up network
capabilities.
6
into the cut in the grommet.
7
stick the transceiver
9
6
3
.
6
on the top of the