Dynalab DGRM-01-02 Panduan Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Timbangan Dynalab DGRM-01-02. Dynalab DGRM-01-02 8 halaman. Rockers - dgrl, dgrm, dsrl & dsrm series

Halaman Cetak

Operation

Always install the carrier or platform before turning on the machine. All platforms or

carriers are shipped in pre-installed status. For safety reason, please check all the locking

screw and tighten again if necessary. The locking screws might be loosened during

transportation!

Place the machines on the flat and steady surface and keep away from other objects for

safe operation.

Check the electrical safety status and the power switch must be in "OFF" position before

plug into the power outlet. The machines come with IEC electrical socket and double fuses

for safety operation.

For the 3D Gyrator Rockers, adjust the tilted angle before loading the samples. Set the

speed to the minimum rpm. And examine the nut underneath the center cylinder shaft

turning front, then stop the machines and tilt the platform to desired angle.

Figure 13: Overview of head box .

Load the samples first before turning on the machine. Be aware of loading sample evenly

and never overload the samples.

Always start with low speed and gradually adjust the speed, especially for the analog

model.

There are two different types of control in most of the mixers: digital and analog. Both

control modes can adjust the speed and timer of the mixers.

1. Digital Control of Speed and Timers

Figure 14: Overview of the front panel of the digital control mode. ①Start/stop

button; ②Mode button; ③Indicator beneath "rpm"; ④ Indicator beneath "time"

There are two buttons and one knob on the digital panel: The knob is the main switch for

turning on the machine and adjusting the speed and timer; the mode button has the