GAI-Tronics XB001 Panduan Memulai Cepat - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Kandang GAI-Tronics XB001. GAI-Tronics XB001 5 halaman. Weatherproof long-life battery enclosure

Halaman Cetak

Model XB001 Weatherproof Long-Life Battery Enclosure

Connecting to the Addressable Amplified Speaker

1. The Addressable Speaker is shipped with only two of the six screws securing the front section to the

rear. Back out the two screws and separate the two sections, carefully setting aside the front section.

Refer to GAI-Tronics Pub. 43004-030 for more detail.

2. Insert the lugged end of the (provided) weatherproof plug cable assembly through the existing cable

bushing located on the bottom of the speaker housing's rear section. Wrap electrical tape around the

cable where it enters the bushing until it has a minimum diameter of 0.25 inch, allowing

approximately 10 inches of cable to remain inside the speaker housing. Tighten the bushing around

the cable.

3. Connect the 3/16-inch male quick-connect fastons from the weatherproof plug cable assembly to the

existing 3/16-inch fastons already attached to the speaker's 11-point terminal strip plug. It is

extremely important to follow the color code noted in Figure 3. Failure to match red to red and

black to black could result in damaged circuitry.

4. Mount the rear section of the enclosure within two feet of the battery box and attach the speaker front

as described in Pub. 43004-030.

5. Insert the speaker cable plug into the receptacle located on the upper left side of the battery enclosure.

Connecting to the RF Call Box

1. Install the customer-provided weather-tight cable bushing in the bottom (right side) of the Call Box

rear section.

2. Remove the lugs from the weatherproof plug assembly, strip the wire insulation 1/8 inch, and insert

the cable through the previously installed cable bushing. Allow enough cable inside the enclosure to

connect the power input terminal strip (P5), located on the PCBA, with the door open. Secure the red

and black wires as noted in Figure 4 below:

3. Close the Call Box door and tighten the screws using 16 to 20 inch-pounds of torque.

4. Mount the External Battery enclosure close enough to the RF Call Box mounting location to allow the

plug cable assembly to be connected to the receptacle located on its upper left side.

\\s_eng\gtcproddocs\radio products-current release\43004\43004-033a\43004-033a.doc

08/08

Figure 4.

Pub. 43004-033A

Page: 5 of 5