Automatic Technology Australia GDO-8 v1 EasyRoller II Panduan Petunjuk Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pembuka Pintu Garasi Automatic Technology Australia GDO-8 v1 EasyRoller II. Automatic Technology Australia GDO-8 v1 EasyRoller II 20 halaman.

Halaman Cetak

PROG INPUT is used for the

connection of the ATA Universal

Programmer for the purpose of

editing

control

and

functions.

P. E. SHUNT. The shunt has to be

removed when connecting a Photo

Electric Beam.

NOTE: P.E. SHUNT must not be

removed otherwise the opener will

not function correctly. Remove

only when a P.E beam is to be

connected.

STATUS LED (Yellow) indicates

when the datum adjustment screw

has reached correct position.

DATUM ADJUST SCREW

Used to set mid point of door trav-

el during limits set up.

DOOR CODE button (blue) is

used for storing or erasing the

transmitter button you wish to use

to command the door to open, stop

or close.

CODING

LED

indicates whether a code is being

stored or when a transmitter button

is pressed.

SET button (orange) is used

during the installation phase

together with the Plus and Minus

buttons to set the door limit

positions. The Set button is also

used to re-initialise the Opener.

OPERATING CONTROLS

OPERATE button (blue) is used

during installation to test the open,

stop and close cycles for the

receiver

opener. The opener has to be

initialised by the Set button before

the OPERATE button becomes

operable.

FORCE MARGIN SET The

obstruction force pressure is set

automatically by the opener during

installation. The pressure can be

adjusted manually using the Force

Margin

Pressing the force margin set

button and open or close button

will increase or decrease the

amount of force. The Force Margin

Set is only ever used if other

environmental factors (wind, etc.)

affect the operations of the

door/opener.

10.

PLUS button (green) can be used

during installation to set the open

limit position. Pressing this button

will move the door in the open

direction. Movement stops when

the button is released.

(red)

light

NOTE:

obstruction

inoperable whenever the Close

Drive button is used to move

door. This button is disabled

after initialisation.

This button is also used to increase

the force margin sensitivity.

Set

button

(White).

The

open

safety

detection

11.

OPEN LIMIT LED (green) the

led

very

helpful

installation. It illuminates and

flashes when the door is opening

and remains steady on when the

open limit position has been

reached.

12.

MINUS button (red) can be used

during installation to set the close

limit position. Pressing this button

will move the door in the close

direction. Movement stops when

the button is released.

NOTE:

The

obstruction

detection

inoperable whenever the Close

Drive button is used to move

door. This button is disabled

after initialisation.

This button is also used to decrease

the force margin sensitivity.

13.

CLOSE LIMIT LED (red) the led

is very helpful during installation.

It illuminates and flashes when the

door is closing and remains steady

on when the close limit position

has been reached.

14.

ENGAGE/DISENGAGEMENT

CORD is used to switch the door

into manual mode especially in

case of a power failure. The length

of the string is also adjustable.

15.

SECURITY

LOCK

MANUAL RELEASE (where

fitted) prevents the manual release

handle being pulled to disengage

the opener into manual mode.

during

safety

FOR