AirCycler g2-k Instalasi & Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Instalasi & Panduan Pengguna untuk Kipas angin AirCycler g2-k. AirCycler g2-k 11 halaman.
Juga untuk AirCycler g2-k: Panduan Pelatihan (20 halaman), Manual Pengujian Instalasi (2 halaman), Manual Pengujian Instalasi (2 halaman)

INTRODUCTION

If the AirCycler® g2 was installed in your home as a ventilation controller, DO NOT DISABLE IT.

In the past, homes depended on natural leaks for ventilation. Today, energy efficient homes are built to reduce natural

ventilation and leaks. Inadequate ventilation can increase indoor air pollutants to harmful levels. Indoor air quality is

typically 5 to 10 times more polluted than outside air. Controlled ventilation provides adequate air flow to the home

without compromising its efficiency.

SAFETY CONSIDERATIONS

Read and follow manufacturer's instructions carefully. Follow all local electrical codes during installation. All wiring

must conform to local and national electrical codes. Improper wiring or installation may result in personal injury or

product and property damage.

The AirCycler® g2 requires 24VAC (R and C terminals) to be connected for proper operation. The controller will not

operate without these two connections.

The wires (R, C, & W ) from the air handler to the thermostat can run parallel with the wiring from the AirCycler®

g2 to the air handler. The fan wire (G) must be interrupted by the AirCycler® g2. Some thermostats do not require a

common (C) connection. The AirCycler® g2 requires this for power, which must be wired to the furnace.

Wiring Diagram

KEY

Vnc - Normal Closed Vent

R - 24VAC Power

W - Heating

Gt - Fan From Thermostat

Gf - Fan to Furnace

C - Common

V - Vent

Ex - Exhaust Fan

AC DOC 8.5

REV 11/21/2014