HID ProxPoint Instal Manual - Halaman 2
Jelajahi secara online atau unduh pdf Instal Manual untuk Pembaca Kartu HID ProxPoint. HID ProxPoint 2 halaman.
Halaman Cetak
PARTS LIST (Included)
- ProxPoint™ Reader with snap-on
cover and 18" cable
- #4-24 x 1" self-tapping flathead screw
- Installation manual
PARTS LIST (Not-Included)
- Wire splice
- DC Power supply 5.1 VDC or 12 VDC
Mounting Instructions
• Determine an appropriate mounting location. The reader
may be mounted to any surface, including metal.
• Drill two (2) 5/64-inch (2mm) holes approximately 1 inch
deep for mounting the reader.
• Drill a 5/8-inch (16mm) hole for the cable.
• Remove the snap-on cover from the reader and secure
the reader to the mounting surface.
• Route the cable from the reader and/or power supply to
the host. A linear type power supply is recommended.
Check all electrical codes for proper cable installation.
• Test the operation of the reader. After completion of the
test, replace the snap-on cover.
• For proper regulatory compliance, the drain wire should
be disconnected at the power supply end of the cable.
• Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
• The Reader is intended to be powered from a limited
power source output of a previously certified power
supply.
•
In cold climates (-20°F), when operating the Reader from
a 5V power supply, limit the cable distance to 200ft. For
longer cable distances, 12V is required.
_____________________________________________________________________________________________________
HID Global 15370 Barranca Parkway, Irvine, CA 92618-1905 USA
Web page - www.hidglobal.com - ProxPoint Installation Manual 6005-910 Rev C.1
Connecting the Reader to the Host
Quantity
Connect the reader to the host according to the wiring
1
table below and the host installation guide.
2
Wiegand
1
+DC
Ground
Quantity
---
Data0
9
Data1
1
Shield Ground
Green LED
Red LED
Beeper
Hold
Testing and Operation
• When power is applied to the reader the LED will
flash green three (3) times while the beeper beeps
simultaneously. The LED will then turn red. This
indicates that the microcontroller is operating
properly.
• Present an ID card to the reader. The LED will
momentarily turn green while the beeper beeps
once,
successfully.
Important Product Specifications
Power requirements (linear supply)
Operating Voltage Range
Peak Current
Average Current 5V or 12V
Maximum cable distance
To host
Maximum cable distance
To host @5V
FCC Compliance Statement: This device complies
with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must
accept
interference that may cause undesired operation.
TEL: 949.732.2000 ● 800.237.7769 FAX: 949.732.2120
Clock & Data
+DC
Ground
Card Present
Data
Clock
Shield Ground
Green LED
Red LED
Beeper
Hold
indicating
that
the
5.1 – 16.0 VDC
80 Ma
20 Ma
500 ft (153 m)
200 ft (61 m)
any
interference
received,
Wire Color
Red
Black
Violet
Green
White
Drain
Orange
Brown
Yellow
Blue
card
was
read
including
Page 2 of 2