Activeforever KA1000 Buku Petunjuk - Halaman 12

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Jam Alarm Activeforever KA1000. Activeforever KA1000 17 halaman. Dual alarm clock with wireless alarm monitoring receiver

Halaman Cetak

ACCESSORIES

The dual alarm clock system is designed to work in correspondence with other wireless

receivers and work with all KA300 transmitters (sold separately). Select from the following to

complete your system.

A. Extended receiver: (KA1000EX)

Turn on the lamp and plug into the extended receiver. Plug the extended receiver into an

AC outlet and the light will ﬂash to notify you everywhere it is placed: kitchen, living

room, bathroom etc. Use light switch to turn on/off light for reading or other activities.

To register the door knock, telephone ringer, baby room call, ﬁre alarm, and weather alert

transmitters with the extended receiver, press the test button on each transmitter and the

light switch on the extended receiver until the red LED on the extended receiver ﬂashes

once. The ID of that transmitter is recorded into memory. (Fig 8)

Press the test button and light

switch until the red LED

ﬂashes once.

Transmitter

If the extended receiver ﬂashes twice, the memory is full. Check the number of registered

transmitters or erase any unused transmitters if needed.

To erase a transmitter from memory, press and hold test button on the transmitter and light

switch of the extended receiver at same time. The extended receiver will ﬂash light twice

to conﬁrm the transmitter code is erased.

To clear the whole memory of the extended receiver, press and hold the light switch until

the LED ﬂashes eight times for clear memories of lamp receiver.

The extended receiver can remember up to 16 different kind of transmitters. For example,

all ﬁre alarm sensors are one kind of transmitters; all door knocks are another kind of

transmitters. Both are considered two kinds of transmitters. This setup gives you the ﬂex-

ibility to install as many transmitters around the building as you desire. It works with all

transmitters that are installed within a 300 feet radius. Each transmitter will ﬂash with a

different pattern for easy recognition.

Tips for installation:

To have the same ﬂashing pattern, write on a piece of paper (page 2 of this manual) the

order of the transmitters you will record into memory. Repeat the same order for each

extended receiver installed after.

Outlet

- 12 -

Lamp

Red LED

KA1000EX