Dynalink RTA210 Panduan Pengaturan Cepat - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Router Jaringan Dynalink RTA210. Dynalink RTA210 15 halaman. Dynalink adsl router quick setup guide
Juga untuk Dynalink RTA210: Panduan Pengaturan Cepat (14 halaman)

Halaman Cetak

ADSL Router Quick Set-up Guide

Default Configuration for New Zealand

We have pre-configured this router to the following settings. If you accept the

settings, please move on to Section 2 "Installing the Router".

Router IP address

Subnet mask

VPI

VCI

Encapsulation

Operating mode

NAT

WAN IP

DHCP

DNS relay

Router configuration and management:

User name

Password

Telnet password

Users must not change VPI, VCI, Encapsulation and Operating Mode settings.

Advanced users who have other setup preferences should refer to the ADSL

Router User Manual on the provided CDROM.

Installing the Router

IMPORTANT- Before you start

Make sure your computer has these installed:

Network interface card (NIC)

TCP/IP protocol.

Other than attaching to a host computer the router can be connected to an uplink

port of a network hub. If the hub has no uplink port available, a cross-over

Ethernet cable must be used. This cable is not provided.

A web browser is required to enter your Internet account user name & password.

Make sure your web browser is Internet Explorer 5.0/Netscape 6 or better. Install

either Explorer 5.5 or Netscape 6 from the provided CDROM if your computer

does not have a suitable browser.

Remember to obtain these from your ISP:

Public IP address (only if you subscribe for static IP)

DNS server IP.

192.168.1.1

255.255.255.0

100

PPPoA VC-MUX

G.dmt

enabled

dynamic

off

admin

private

(do not change)