HID FARGO HDP 6600 Panduan Instalasi
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Printer HID FARGO HDP 6600. HID FARGO HDP 6600 2 halaman. Lamination module
Juga untuk HID FARGO HDP 6600: Panduan Pemeliharaan (12 halaman)
Halaman Cetak
INSTA LLATION GUIDE
FARGO® HDP®6600
Lamination Module
Installation to a HDP6600 (without a Dual Side Module)
Follow these instructions to connect the HDP6600 Lamination Module directly to a
HDP6600 printer, without a Dual Side Module. Alternatively, scan the QR code or visit
http://hid.gl/HDP6600-Lam-upgrade-SS
side of this sheet if you have a Dual Side Module.
Before you begin:
Download and install the latest HDP6600 printer driver and firmware from
https://www.hidglobal.com/drivers
Switch off the printer and unplug the power cord
Unplug any USB and Ethernet cables from the printer
1
Remove the output bin from the printer (if
attached).
4
Move the blue lever on the lamination
module down. Align the posts and slide the
lamination module into place. Move the blue
lever up to lock.
7
Replace the printer and lamination module
access covers.
© 2019 HID Global Corporation/ASSA ABLOY AB. All rights reserved. This document may not be reproduced, disseminated or republished in any form without the prior written
permission of HID Global Corporation. HID GLOBAL, HID, the HID Brick logo, the Chain Design, FARGO, and HDP are trademarks or registered trademarks of HID Global, ASSA
ABLOY AB, or its affiliate(s) in the US and other countries and may not be used without permission. All other trademarks, service marks, and product or service names are
trademarks or registered trademarks of their respective owner.
hi dg l o b a l.com
to view the installation video. Refer to the other
2
Remove the access cover from the printer.
5
Connect the lamination cable to the
printer connector (labeled pink).
8
Connect the power cords to the printer
and the lamination module.
An ASSA ABLOY Group brand
PLT-04395, Rev A.1
3
Remove the access cover from the
lamination module.
6
Attach the output hopper supplied with
the lamination module. Do not use the
output hopper supplied with the printer.
9
Connect the USB/Ethernet cables to the
printer (as required) and switch on the
printer.