2gig Technologies GC3 Manual - Halaman 2

Jelajahi secara online atau unduh pdf Manual untuk Panel Kontrol 2gig Technologies GC3. 2gig Technologies GC3 4 halaman. Lte cellular radio module
Juga untuk 2gig Technologies GC3: Panduan Memulai Cepat (2 halaman)

Halaman Cetak

2. Disconnect Power from the panel

a. Barrel Connector: (A) Disconnect the

power supply from the outlet. Remove

the barrel connector plug from the barrel

jack on the panel.

NOTE: If a sounder or other wire

connections are attached, disconnect

them as well. Note the connection points

in the terminal block.

b. Terminal Block: (B) Remove 2-conductor

power wire from the PWR+/PWR- screw

positions on the panel's terminal block.

3. Remove the panel from the wall by

detaching the THIRD HAND strap from the

hanger.

a. Place the control panel onto a flat surface

with the front facing downward, taking care

not to scratch the front panel surface.

4. Disconnect the wired battery pin connector

from the PCB battery connector port. The

connector is located directly behind the DC

power adapter barrel jack.

REMOVING THE EXISTING BATTERY

Gently push the battery away from the side TAB

1, and lift the battery out once the battery edge

has cleared TAB 1.

NOTE: Avoid using excessive force to

prevent breakage of the TABS. Do not

use any tools or sharp instruments in

order to avoid damaging the panel or

puncturing the old battery.

If needed, try pulling away from TAB 2

while lifting the battery out in order to

clear both tabs.

NOTE: Some earlier panel versions

may not have TAB 2.

Third Hand

GND

ZONE 2

ZONE 1

BELL –

BELL +

GND

PWR-

PWR+

TAB 2

Disconnect

2-Conductor

Power Wires (if in use)

TAB 1

Apply Pressure

to Clear TAB 1

Disconnect

Barrel Power

Connector

(if in use)