Automation Direct DL06 Panduan Pengguna
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Monitor Automation Direct DL06. Automation Direct DL06 2 halaman. Lcd display
Halaman Cetak
DL06 PLC LCD Display
DL06 LCD D
The optional D0-06LCD is a
cost effective operator interface that is
easy to install. This device is available
exclusively for the DL06 PLCs.
16 X 2 backlit display
The 16 character x 2 row operator inter-
face mounts directly on the face of the
PLC. The LCD is backlit and is acces-
sible using the seven function keys on
the front of the display.
Monitor or change
data values
You can view V-memory registers, view
I/O status, PLC mode, or system errors
without interrupting the PLC's control
function.
Display messages required for alarm or
monitoring purposes can be prepro-
grammed or imported as ASCII data.
Password protection
Two layers of password protection
prevent unauthorized changes to clock
and calendar setup and V-memory data
values. Individuals with password autho-
rization can change clock, calender, V-
memory values, force bits on or off, etc.
276
PLC and PC Products
ISPLAY
One simple ladder instruction is used to
set up the display. The LCD configura-
tion
instruction
DirectSOFT32, version 4.0 or later.
Note:
The
D2-HPP
programmer does not support DL06
LCD configuration.
The DL06 User Manual (D0-06USER-
M) describes more fully the installation
and operation of the D0-06LCD. Be
sure to consult this manual before
installing the DL06 LCD. The manual is
available free on our Web site, or it can
be purchased separately.
Snap-in installation
The display installs easily into any model
DL06 PLC.
Note: Remove power to the PLC before
installing the LCD display.
Remove the plastic cover (located
between the input and output terminals)
by sliding the cover to the left. In its
place, slide in the LCD display until it
snaps into place.
Display or change individual bits (up to
16 bits per screen) or 32-bit double word
values from V-memory.
Buzzer
The piezo electric buzzer can be config-
is
available
in
ured to provide pushbutton feedback.
Keypad navigation
handheld
Seven function keys on the face of the
LCD display provide navigation through
messages or menu items. Messages fall
into two categories:
• Error messages
• User-defined preprogrammed messages
At power-up the default screen is
displayed. The default screen can be
user-defined.
Seven menu choices allow you to view or
change all accessible data values (see next
page).
Left
Up
Right
Down
Escape
Enter
Menu