Gainlab Audio GLA-TC2 Manual - Halaman 9
Jelajahi secara online atau unduh pdf Manual untuk Peralatan Perekaman Gainlab Audio GLA-TC2. Gainlab Audio GLA-TC2 13 halaman.
Juga untuk Gainlab Audio GLA-TC2: Panduan Kalibrasi (18 halaman)
Halaman Cetak
SIDECHAIN FILTER
circuit below a set cut-off frequency. To set the filter, move the switch labeled SC.
FILTER so that the switch's LED indicator points towards the cut-off frequency
value below which you no longer want to allow a signal to go to the auxiliary
circuit
POWER SWITCH
The unit is switched on with the switch marked POWER. Set the switch
labeled POWER to the up position if you want to turn on the unit. Set
the switch labeled POWER to the down position when not in use.
Due to the tube design of the device, it is advisable to leave a "warm-up
time" of 15-20 minutes before starting use.
ATTENTION! the switch labeled POWER puts the device in standby
mode, does not completely disconnect it from the mains, if you
want to disconnect the device completely from the mains, unplug
the device from the mains or switch off the main switch at the IEC
socket !
GROUND LIFT
DICTATOR DUAL MONO VARI-μ
Depending on the program signal, it is often necessary
for the dynamics controller not to react to deep
frequency components. In such cases, it is advisable to
filter out these low-frequency components from the
auxiliary circuit signal controlling the compressor with a
high-pass filter that does not allow a signal to the control
The switch on the back of the device allows the outgoing audio
connection to be disconnected from ground, thus eliminating
ground loop phenomena that occur under certain conditions. To
adjust the ground defrost, set the GROUND LIFT switch on the
rear panel to the up position.
8