Gree 13-04685 Panduan Petunjuk Pengoperasian - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pendingin Udara Gree 13-04685. Gree 13-04685 20 halaman.
Halaman Cetak
Installing the Unit in a Casement Window
NOTE: Open the window the maximum
amount to allow for clearance of the cabi-
net. The crank handle should be removed to
allow the platform to be fastened to the
jamb. If the window cannot open far
enough (more than 15-1/2 inches) for the
cabinet to clear the window, remove the
window entirely by drilling out the rivets.
Bolts can serve as the pivots in the future.
To avoid crank handle and window clear-
ance problems, the unit can be installed in a
stationary sash section. However, the hori-
zontal mullion and the
2 glass panels must be removed before
installation.
1. Attach support brace to platform as
shown. Use the adjustment bolt and hex
flange nut to complete the assembly. Choose
the slot and adjustment bolt hole locations
that will create a 45 degree angle between
the platform and the support brace. Try the
assembly in the window to determine if the
platform will rest properly, and allow the
proper slope (3/16- inch lower on outside).
NOTE: If you are planning to use a siding
protection board (see Step 6) on the outside
of your house, hold the board in place when
testing the assembly in the window.
2. Drill a 9/64-inch diameter pilot hole in
the window jamb an equal distance from
each side of the jamb, and 3/16-inch up
from the window sill. If the hole coincides
with the window lever slot in the jamb bot-
tom, an additional hole will have to be
drilled through the platform edge and the
window jamb to miss this slot.
3. Peel off the protective backing from the
track seal, and stick the seal to the win-
dow sill on the outside of the bottom
jamb.
4. Screw the platform assembly to the win-
dow jamb through the pilot hole you drilled
in Step 2. Use a #8x3/4-inch self-threading
screw.
(continued)
1/4" (6mm) HEX
FLANGE NUT
Equal distance from both sides
8 11/16 po
Apply track seal to the outside edge of the
bottom window jamb.
Track seal
Screw
Window
jamb
9
Platform Assembly