Gainsborough SD8PLUS Ilustrasi Petunjuk Pemasangan

Jelajahi secara online atau unduh pdf Ilustrasi Petunjuk Pemasangan untuk Dengan kunci Gainsborough SD8PLUS. Gainsborough SD8PLUS 2 halaman. For sliding screen doors

Halaman Cetak

SD8/SD8PLUS

for sliding screen doors

MADE IN AUSTRALIA BY

Austral Lock

ILLUSTRATED FITTING INSTRUCTIONS

156mm

16mm

Door Cutout

IMPORTANT : If installing SD8 with a multipoint accessory

kit, be sure to follow the cylinder installation procedure

within the multipoint kit instructions.

Assemble the cylinder through the lock so

the cylinder protrudes equally from both sides.

Note: The cylinder cam must rotate as

shown below. (cam turns towards front of door)

Insert the key and turn to locked position.

Insert #10 x 38mm cylinder screw & tighten.

Note: Test - beak should not depress.

Turn key to unlocked position and remove key.

Spindle Selection

Break the spindle pair in two.

Select the correct spindle according to

diagram below:

'L' spindle is

used with 'L'

furniture plate

The sticker on the rear of the lockbody is to

assist in easy installation. - Do not remove.

If the sticker has been broken or removed,

ensure that the rear slide is pushed

completely down before assembling the

lockbody into the door cutout.

lockbody

sticker

rear slide

cylinder

cylinder cam

Spindle and Slide Assembly

Visually check if the interior furniture plate

(being fixed on the inside of the door), is

marked with an 'R' or 'L', and install the

corresponding 'R' or 'L' spindle. The remaining

spindle can be discarded.

Assemble the spindle, slide and retaining

plate as shown below.

'R' spindle is

used with 'R'

furniture plate

PLEASE TURN PAGE FOR INSTALLATION STEP 8.

Preparation

Cylinder Installation

beak

cylinder

screw

cam operation

Note: Spindle needs to

match the corresponding

'R' or 'L' furniture plate

Slide

Retaining

plate

Lockbody installation

Insert the lock body into the door cutout.

Secure the lockbody with two #8 x 13mm

lockbody screws.

door cutout

Exterior Furniture Preparation

Select the exterior furniture assembly to

be placed on the outside of your door, then

insert the two screw spiggots into the

exterior lever plate.

Install the exterior plug as shown.

screw

spiggots

Furniture Installation

Place the exterior furniture assembly over the

cylinder and hold it against the door.

Secure both furniture assemblies together

using the two #8 x 32mm furniture assembly

screws.

Note: Ensure the

square drives on the lever

and spindle are guided into the lockbody.

Push the two plugs provided into the screw

holes in the interior furniture assembly.

Furniture

screws

(Pk0153) SD8 Instructions (A4) R2

lock body

screw

exterior

plug

Screw

plugs