Dynamatic 15-539-14 Lembar Instruksi

Jelajahi secara online atau unduh pdf Lembar Instruksi untuk Pengontrol Dynamatic 15-539-14. Dynamatic 15-539-14 14 halaman.

Instruction Sheet

IS-539-14

revised 2019

15-533-1014 Panel Mount 4000 (4.3 A Controller)

15-535-1014 Standard Enclosure 4000 (4.3 A Controller)

15-539-0014 Panel Mount 4050 (8 A Controller)

15-540-0014 Standard Enclosure 4050 (8 A Controller)

Model 4000 and 4050 with Torque Speed

Introduction:

These instructions relate specifically to the

following Model 4000 and 4050 controllers

which are assembled for Speed Control with

the Torque Limit Modification.

Connection diagram, schematic diagram,

switch

programming,

connection, adjustment procedure and

recommended spare parts list for these

specific assemblies are contained in this

instruction sheet. Any differences between

these two controllers are clearly noted.

Use instruction manual IM-13006-83XX with

this

instruction

and

instructions.

Caution: Above ground electrical potentials

can be hazardous. Always disconnect

electrical power before working on the

controller.

*Heat sink assembly, HS1, and its wiring

apply only to the Model 4050 controllers.

These parts are not supplied on Model 4000

controllers. The parts are mounted on the

15-530-5 main 4000 board.

plug

wiring

maintenance

Drive Source International/Dynamatic

7900 Durand Ave Bldg 3 Sturtevant, WI 53177

800-548-2169 •

www.Dynamatic.com

15-539-14