GainSpan GS1011MEE-DB Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Motherboard GainSpan GS1011MEE-DB. GainSpan GS1011MEE-DB 12 halaman. Serial to wi-fi evaluation kit

Halaman Cetak
S
W
-F
ERIAL TO
I
Below are the steps required to run the serial to Wi-Fi application.
1. Once the software installation is completed, power the Wi-Fi Access Point (AP). The access point
have been pre-configured with the following parameters:
a. SSID = "GainSpanDemo
b. Channel = 6
c. DHCP = Enabled
d. Security = Open
e. IP Address = 192.168.3.1
Note: If user wants to use a different AP than the one provided with the kit, user can use any standard
Wi-Fi (802.11 b/g/n) AP, they should just ensure that the AP settings match the parameters above.
2. Plug the serial cable provided directly into a serial communications port of the PC if one is
available, or into a USB-to-serial converter. Since USB converters can enumerate to any one of a
number of COM ports, it is necessary to find the COM port of the serial port or USB converter being
used to communicate with the board. Open the Device Manager (Figure 1): Start → Settings →
Control Panel → System → Hardware → Device Manager. The USB Serial Port is listed under
as shown below
(COM & LPT),
Figure 1: System Properties pane with Device Manager Button
P
RELIMINARY
S
S
I
ETUP AND
TART
.
P
4
AGE
Serial to Wi-Fi Start Up Guide
U
I
P
NSTRUCTIONS
12
OF
Ports
C
ONFIDENTIAL