Hideaway Soft Close Petunjuk Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Peralatan Dapur Hideaway Soft Close. Hideaway Soft Close 2 halaman.

Halaman Cetak
•
NOTE: Lightly tighten nuts to allow fixing of door front.
Step 7 - Fix cabinet fascia to door bracket of bin
•
Place a 4mm self tapping screw into the centre hole of the door bracket - ensure the point of the
screw is only protruding approx 3mm.
•
With the bin closed fully, align the front fascia of the cupboard against the door bracket. A small hit
with your hand to the location of the screw will help provide a drilling indication.
•
Lie cabinet fascia on a flat surface with the internal part of the door facing upwards. Using the
drilling mark made to the centre point on the cabinet fascia, drill a hole to hold centre screw (if
required for ease of installation, remove the door bracket from the unit once again. Attach the door
bracket with the centre screw to the cabinet fascia and then reattach the door bracket to the collar
of the bin once again.)
•
Place the cabinet fascia against the door bracket and tighten the centre screw. Check the
positioning and align.
•
Proceed to marking, screwing and tightening the remaining screws. Vertical and horizontal
adjustment is provided on the door bracket.
•
To adjust the angle of your kitchen fascia: loosen or tighten the nuts on the door bracket until
desired angle is achieved. The centre nut provides pivot. Once the desired angle is achieved,
firmly tighten all nuts on the door bracket.
IMPORTANT INSTALLATION INFORMATION: At all stages of the
installation ensure the spring carrier on the runner is engaged.
Before you close the unit ensure the spring carrier is loaded on your soft close runner. Failure to
do so will cause damage to your runners. In all cases replacement is required.
Figure 5a - demonstrates the spring carrier in the engaged position. This is the correct positioning
and the bin is ready to be closed and used.
Figure 5b - demonstrates the spring carrier in an unengaged position. This is incorrect positioning
and will cause damage to your runners. To move into engaged position, move the white spring
carrier along its runner until it clicks into location demonstrated by arrow in diagram below.
Figure 6 - demonstrates a damaged runner. If you do not check your runners and ensure at all
stages the spring carriers are in an engaged position you will bend the white guiding arm on the
shock absorber. Once this has happened you have damaged your runners and will require new
ones. The supply of new runners, without additional cost, is at the discretion of Kitchen King Ltd
in all cases.
Step 8 - Place bin buckets into checkouts on collar
•
Fully extend the runners.
•
Place bucket/s into the checkouts provided on the collar. The back bucket must sit over the lip on
the back of the frame. If the bucket/s do not sit within these checkouts the unit will not close
properly.
•
Trade
- please leave the Glad sample pack inside the bucket.
•
Homeowner
– you will find a Glad sample pack in the base of your bucket. Slide the Glad Kitchen
Tidy Bag into your bucket/s ensuring the bag will not interfere with the tracks. (NZ only)
•
Place liner holders on top of bucket/s.
Installation complete!
Questions?
NEW ZEALAND
Phone 09 426 7456
AUSTRALIA
Freephone 1800 042 642
Web www.hideawaybins.co.nz
Web www.hideawaybins.com.au
Fig 4b
Lid coming
free of hook
Hook
Metal support
Fig 4c
The unit should look like this
with the friction-fitted lid and
door bracket removed
Fig 5a Runner engaged - correct
Fig 5b Runner unengaged - incorrect
Fig 6 Damaged runner - requires
replacement
NZ Pat Appln No. 585372