Dynamco CYCLOPS PARALYSER 485 Petunjuk Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Sistem Keamanan Dynamco CYCLOPS PARALYSER 485. Dynamco CYCLOPS PARALYSER 485 13 halaman.

Halaman Cetak

ENGINE IMMOBILISATION

Engine immobilisation is usually provided by the vehicle's original equipment

system. The P485 does provide another two independent circuits of

immobilisation, however they are only connected at special request (extra cost).

GLASS BREAKAGE PROTECTION

The P485 is equipped with a sophisticated glass breakage detection unit. The

system will only respond to the breaking of glass in the vehicle (sound can be

muffled by heavy window tinting). To test the unit simply wind up all the windows

and arm the P485. Wait 30 seconds before tapping the driver's side window with a

metal object such as a coin. The siren and indicators will sound and flash. Dull

thumping of the windows should note produce a trigger. Be careful not to smash

any windows.

PROGRAMMABLE OPTIONS

The P485 has a number of options that can be set or reset by means of the

ignition switch. To change these options you need to do the following:

Open the bonnet and driver's door, these must remain open during the entire

procedure.

Turn the ignition switch from ACC position to the ON position the required number

of times (see table on next page). Leave the switch in the ON position when the

required number is reached.

The vehicle indicators will flash approximately two seconds after last turn. Three

flashes shows that the option is set and one flash shows it has been reset.

- Page 5 -