Hideaway Beds Next Bed King Manual Petunjuk Perakitan - Halaman 4

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Perabotan Dalam Ruangan Hideaway Beds Next Bed King. Hideaway Beds Next Bed King 7 halaman.

Halaman Cetak

Section 4: LEG ASSEMBLY

Stand the assembled frame. Lift and set the hinge
11.
axles of the Head Frame (B) into the hinges of the
Yoke Assembly.
Stabilize the frame in the vertical position by
12.
applying one spring on either side (Photo 1).
Attach Legs (N) to Side Rails (D), see Detail A.
13.
Do not over tighten so Legs may pivot freely.
M6x42mm Bolt, Spacer, Washer, Nylock Nut (2 sets)
14.
Attach Leg Connector Tube (M) to Legs (N) as shown.
M6x16mm Bolt (4 sets)
15.
Attach Actuator Bars (E) to the Leg Brackets (N)
with Cotter Pins (see Detail A), then to the Floor
Yokes (H) with Cotter Pins. Bend back ends to secure.
Cotter Pins, Washers (4 sets)
16.
Rotate the bed down horizontal and install the
Slats (Q) by slipping one end into the closed Slat
Holder and flexing the slat slightly and tapping it
into the open ended Slat Holder.
17.
Put Mattress in place and secure with Nylon Web Strap.
Install proper number of Springs to balance. Raise
18.
bed frame with mattress to the vertical position. Add
an equal number of springs on each side until the
bed frame is almost weightless at the 45* angle.
Remem-ber that the system will weigh slightly more
when bedding is added to the system. See Photo 1.
19.
Install the Spring Covers (L) to the Bottom Spring
Tube (J) to cover the installed springs.
M6x10mm Bolt (4pcs)
20.
Adjust the Wall Mount Brackets on the Yoke Assembly to have the bed
operate at the minimum distance from the wall.
4.
Updated130717MWBS
Photo 1
First hook bottom of spring in
the Bottom Spring Tube (J),
then using vice grips pull up
and set the top spring hook.
You may use leverage from
the Yoke Connector Bar (I).
Tighten bolts in place.
Detail A - not full scale
inside of frame
(D)
(N)
Detail A
cotter
pin
washer
(E)