AutomationDirect SureServo2 Panduan Memulai Cepat - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pengontrol AutomationDirect SureServo2. AutomationDirect SureServo2 2 halaman. 110/220 vac drives
Juga untuk AutomationDirect SureServo2: Manual (18 halaman), Panduan Memulai Cepat (4 halaman)
Halaman Cetak
Wiring
• Higher than maximum specified current may cause demagnetization of components inside the motor.
• Before operation ensure that the motor, brake and encoder are connected correctly. Incorrect
wiring will cause abnormal motor operation or result in permanent damage to one or more of the
components.
• To eliminate electrical noise on the encoder ensure adequate separation of the motor power wires
and the encoder wires.
• Ensure that the motor ground wire is connected to the ground terminal on the servo drive.
• Do not perform a dielectric voltage-withstand test on any encoder terminal.
• Disconnect the motor from the drive before performing a dielectric voltage-withstand test on the
motor.
Operation
• The AC servo motor is designed to operate through a dedicated SureServo2 servo drive. Do not
connect it directly to a commercial power source (120/240/480V AC or DC, 50/60Hz). The motor will
not operate correctly and may be permanently damaged.
• The motor must be operated within its specified range. Attention should be given to ensure adequate
cooling and ventilation of the motor during operation.
• The material of the motor shaft is not totally rust-proof. For long term use, the motor shaft should be
recoated with proper and sufficient antirust oil during the period of operation.
• The built-in brake is designed to hold the motor shaft when stationary. It must not be used to
dynamically brake or slow down the motor during rotation. The motor brake is not designed as a
safety feature for the attached mechanism or machine. A separate safety device must be installed
on the machine to ensure adequate safety measures are undertaken. When the brake is holding
the motor shaft, rotational backlash still remains. The maximum angle of rotational backlash is 1 to
2 degrees. In addition, during the operation of the motor with brake, the brake lining sometimes
produces noise, such as a clicking or rustling sound, etc. The noise is caused by the brake module, not
because of malfunction. It will not affect the function of the motor.
• Should any abnormal odor, noise, smoke, temperature rise or vibration be detected, stop the motor
immediately, remove power from the servo drive and isolate the motor.
Additional Help
For additional information, please see the full SureServo2 User Manual, available on our website at
www.automationdirect.com/manuals.
By Telephone: 800-633-0405 (Mon.–Fri., 9:00 a.m.–6:00 p.m. E.T.)
Our technical support group is glad to work with you in answering your questions. If you cannot
find the solution to your particular application, or, if for any reason you need additional technical
assistance, please call Technical Support at 800-633-0405. We are available weekdays from 9:00 a.m.
to 6:00 p.m. Eastern Time.
We also encourage you to visit our web site where you can find technical and non-technical
information about our products and our company. Visit us at www.automationdirect.com.
SureServo2 Motor Quick Start Guide – First Edition - 05/20/2021
On the Web: www.automationdirect.com
SureServo2 Motor Quick Start Guide
Page 2 of 2