Celestron PowerSeeker 127EQ Pengaturan Cepat

Jelajahi secara online atau unduh pdf Pengaturan Cepat untuk Teleskop Celestron PowerSeeker 127EQ. Celestron PowerSeeker 127EQ 2 halaman. Celestron powerseeker 127eq: quick setup
Juga untuk Celestron PowerSeeker 127EQ: Buku Petunjuk (16 halaman), Panduan Pengaturan Cepat (2 halaman), Panduan Pengaturan Cepat (10 halaman), Panduan Pengaturan Cepat (20 halaman), Panduan Pengaturan Cepat (2 halaman), Panduan Pengaturan Cepat (2 halaman)

PowerSeeker 127

Item# 21049

Your PowerSeeker 127 includes: optical tube w/

tube rings attached; tripod with center support

bracket; equatorial mount; two eyepieces; a 3x

barlow lens, finderscope; 5 lb. counterweight;

counterweight bar; two slow motion cables;

eyepiece accessory tray; The Sky™ CD software;

documentation including owner's manual.

All three legs should be the same length to

provide a level platform for the telescope.

Locate the equatorial mount and place the

base of the mount through the hole in the

center of the tripod mounting platform.

Celestron Technical Support: 310

Item #31132

To set up the tripod, spread the legs outward

until they are fully extended. Extend the center

portion of each of the three tripod legs down 6-

8".

Place the accessory tray on top of tripod's

center leg brace. Thread the tray into the

threaded hole in the center of the leg brace.

From underneath the tripod mounting platform,

thread the mounting bolt with washer into the

threaded hole on the bottom of the equatorial

mount.

Questions or Problems with Set-up?

CONTACT:

For detailed usage information please

consult your owner's manual.

Quick Set-up Guide

Use the three tightening screws located at the

bottom of each leg to secure the extended legs

in place.

Properly assembled, the accessory tray should

appear as pictured above.

Thread the latitude adjustment screw into the

equatorial mount until it is touching the inside

of the mount.

803

5955