DynaMetric TMP-636 Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk untuk Adaptor DynaMetric TMP-636. DynaMetric TMP-636 3 halaman. Telephone transmit & receive patch for use with sound card or tape recorder
Juga untuk DynaMetric TMP-636: Manual (4 halaman)

Halaman Cetak

INSTRUCTIONS

TMP-636 Telephone Transmit & Receive Patch

For Use With Sound Card or Tape Recorder

Record & Playback Software

You may use recording software that came with your sound card, Windows Sound Recorder, or

other software. Below are instructions for Windows Sound Recorder. Be sure to read the

Feedback section no matter what software you use.

Instructions for Windows Sound Recorder

Windows Sound Recorder can be found on your computer, starting at the Start button:

Start button – Programs – Accessories – Entertainment – Sound Recorder

Likewise, Volume Control can be found:

Start button – Programs – Accessories – Entertainment – Volume Control

RECORD - Set the output 'Volume Control' (the one on

the lift side) to minimum or check the 'Mute all' box. Set

the 'Microphone' volume to about half way, and un-check

the Microphone Mute box. Make a phone call, and push

the Record button (red circle) on the Sound Recorder.

As you talk into the phone, your voice will be visible in

the Sound Recorder window.

Adjust the Microphone

Volume control as necessary. In some versions, there is

a button marked 'Advanced' is in the Microphone section,

which may provide a Mic Boost function. Use this only if

necessary. Listen to your recording in PLAY to make

sure your Microphone Volume is set correctly.

If the

playback is distorted, turn down the Mic Volume control.

Push the Stop button (black square) to end the recording.

Sound Recorder's maximum recording time is 1 minute.

PLAYBACK - Set the Mic Volume control to minimum or

check the Mic Mute box. Set the output 'Volume Control'

(on left side) and the Wave volume controls to mid range,

and un-check their Mute boxes. Push Play (black arrow)

to begin playback. Adjust the output and Wave volume

controls to get the best sound. The recording can be

saved with the SAVE command in the Sound Recorder

'File' menu.

FEEDBACK – Feedback can occur when the output

signal from your sound card goes through the TMP-636

to your phone mic, the phone transfers the signal to the

handset earphone, which is picked up by the TMP-636

and sent back to the sound card Mic input. If the Mic and output volume controls are both on,

then the signal goes around and around the loop. Feedback may be audible (a loud tone or

squeal), or inaudible and just cause noise, distortion and/or very low record levels. Always

make sure that the output and Mic controls are not on at the same time to avoid feedback.

FOR LEGAL USE ONLY

8-21-01

www.DynaMetric.com

Page 3 of 3