DB Drive EUPHORIA EDSP4-31BT Panduan Pengguna - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Perekaman DB Drive EUPHORIA EDSP4-31BT. DB Drive EUPHORIA EDSP4-31BT 15 halaman. 31 band digital sound processor with built-in amplifier
Halaman Cetak
Note: EDSP4-31BT can only be connected to a computer
with a USB cable.
• Ensure that EDSP4-31BT is powered on while the USB
cable is connected to a computer.
• The computer will automatically install and update the
device drivers.
• The EDSP4-31BT software will automatically sink- up
with the on-screen GUI. At this point, in the top left
corner, the Input Signal Selection and Connection Status
area will indicate green "connected" state.
3.3 Software Interface
Figure 3.3.1
12
12
As shown above in Figure 3.3.1, the software interface of the
EDSP4-31BT GUI is divided into 6 areas:
1. Input Signal Selection and Connection Status.
2. Mixer
3. Main Menu
4. Crossover & Equalizer Adjustments
5. Time Delay Adjustments
6. Output Channel Configuration
3.4 Audio Input Signal Selection
• While connected to a computer, select the appropriate
audio input source in the Input Signal Selection and
Connection Status area.
• The input selections are High Level, AUX, Phone and
Player. The audio input signal can be selected from the
audio input drop-down menu. The default source is high
level.
• Each input source signal gain can be adjusted in the Mixer
area. The adjustable range is 0-40.
3.5 Output Channel Configuration
Step 1: Select the channel you want to edit in the Output
Channel Configuration area of the interface.
-
CH1 - 6 are used for full range frequencies
-
CH7 - 8 are used for low frequencies.
Step 2: You can switch between channels to individually adjust
parameters respectively.
Step 3: Repeat the process with each channel that you wish to
adjust.
13
13