AutomationDirect IRON HORSE GSD5 Series Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penggerak DC AutomationDirect IRON HORSE GSD5 Series. AutomationDirect IRON HORSE GSD5 Series 16 halaman.
Installation and Wiring – Wiring Diagrams (continued)
GSD5-240-10N4 Basic Wiring Diagram
Min
Max
Inhibit
P2
Pin
P1
-1 -2 -3
-4 -5 -6 -7
chassis
ground
motor
armature
Endplate with holes for 1/2" NPT conduit
GSD5-240-10N4-V Basic Wiring Diagram (Factory installed Voltage Follower input option)
Min
Max
Accel
Comp
(red)
Inhibit
P2
Pin
(white)
(orange)
P1
-1
-1 -2
-3
-4 -5 -6 -7
motor
ac input
IronHorse GSD5 DC Drives User Manual – 1st Ed, Rev E – 05/13/2020
IR
Cur.
Accel
Comp
Lim.
(white
yellow)
-8
-9
-10
-11
field*
* Field terminals are used for shunt-wound motors only!
ac input**
** AC1 terminal is internally fused; AC2 terminal is NOT
IR
Cur.
Lim.
(black)
(brown)
(white)
(yellow)
-8
-9
-10
-11
GSD5-240-10N4-V
(INSIDE OF COVER)
CUSTOMER WIRING
INPUT IMPEDANCE:
1.2MW on high scale
150KW on low scale
FACTORY PREWIRING
HI (white)
WIPER (red)
LO (orange)
DPST SWITCH
(black)
or
(white)
(black
or brown)
INSIDE OF COVER
CUSTOMER WIRING
Do not connect these terminals when using
permanent-magnet motors.
internally fused. Add external fuse for AC2 if it is
connected to a hot AC line.
FACTORY PREWIRING
3PDT Switch
(yellow)
(brown)
Speedpot
(red)
(white)
(white)
(black)
P2
Vin or 4-20mA
CONNECTOR
RANGE
4-20 Vin
JP2
JUMPER
CONNECTOR*
-1 -2 -3
P4
GAIN
TRIMPOT
BALANCE
TRIMPOT
P3
P5
common
SPEEDPOT
NOTE: SOME
FACTORY WIRING
IS NOT SHOWN
FOR CLARITY
(orange)
* Jumper clip is used to select
input voltage range. When
installed from P4-1 to P4-2,
the range is 0–25 VDC thru
0–250 VDC. When installed
(blue)
from P4-2 to P4-3, the range
is 0–5 VDC thru 0–25 VDC.
analog
analog
speed
speed
signal
Page 9