Celestron PowerSeeker 60AZ Panduan Pengaturan Cepat
Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Teleskop Celestron PowerSeeker 60AZ. Celestron PowerSeeker 60AZ 2 halaman. Celestron powerseeker 60: quick setup
Juga untuk Celestron PowerSeeker 60AZ: Buku Petunjuk (10 halaman), Buku Petunjuk (9 halaman)
Halaman Cetak
PowerSeeker 60AZ
Item# 21041
1
Your PowerSeeker 60AZ includes: optical tube with
two threaded mounting bolts; tripod with center
support bracket & yolk mount attached; two
eyepieces; a 3x barlow lens, finderscope; star
diagonal; slow motion control rod; eyepiece
accessory tray; The Sky™ CD software; owner's
manual.
4
All three legs should be the same length to
provide a level platform for the telescope.
7
Locate the optical tube and line up the tube
with the holes on the mount.
Item #31132
Celestron Technical Support: 310
2
To set up the tripod, spread the legs outward
until they are fully extended and push down
center locking brace. Extend the center portion
of each of the three tripod legs down 6-8".
5
Place the accessory tray on top of tripod's
center leg brace. Thread the tray into the
threaded hole in the center of the leg brace.
8
Secure the tube to the mount using the two
threaded mounting bolts. Tighten to secure in
place.
Questions or Problems with Set-up?
CONTACT:
Quick Set-up Guide
3
Use the three tightening screws located at the
bottom of each leg to secure the extended legs
in place.
6
Properly assembled, the accessory tray should
appear as pictured above.
9
Insert the slow motion control rod into the hole
on the mount.
.
.
803
5955