Celestron POWERSEEKER 80 EQ Panduan Pengaturan Cepat

Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Teleskop Celestron POWERSEEKER 80 EQ. Celestron POWERSEEKER 80 EQ 10 halaman. Celestron power seeker telescope instruction manual eq 80
Juga untuk Celestron POWERSEEKER 80 EQ: Buku Petunjuk (20 halaman)

Halaman Cetak
Celestron POWERSEEKER 80 EQ Panduan Pengaturan Cepat
PowerSeeker 80EQ
Item# 21048
1
Your PowerSeeker 80EQ includes: optical tube; tripod;
equatorial mount; latitude adjustment screw; diagonal;
2 eyepieces; a 3x barlow lens; finderscope; 4 lb.
counterweight; counterweight bar; two slow motion cables;
accessory tray; The Sky
®
Level 1 software, owner's manual.
4
All three legs should be the same length to provide a level
platform for the telescope.
7
Locate the equatorial mount and place the base of the mount
through the hole in the center of the tripod mounting
platform.
Item #31132
Celestron Technical Support: 310
2
To set up the tripod, spread the legs outward until they are
fully extended and push down center leg brace.
5
Place the accessory tray on top of the tripod's center leg
brace. Thread the tray into the threaded hole in the center of
the leg brace.
8
From underneath the tripod mounting platform, thread the
attached mounting bolt into the hole on the bottom of the
equatorial mount.
Questions or Problems with Set-up?
CONTACT:
Quick Set-up Guide
3
Extend the center portion of each of the three tripod legs
down 6-12". Use the three tightening screws located at the
bottom of each leg to secure the extended legs in place.
6
Properly assembled, the accessory tray should appear as
pictured above.
9
Thread the latitude adjustment screw into the equatorial
mount until it is touching the inside of the mount.
.
.
803
5955