Dynamic DT1050 Panduan Pemilik

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Pengendalian Serangga Dynamic DT1050. Dynamic DT1050 2 halaman. Flying insect trap

Halaman Cetak

OWNER'S MANUAL

FLYING INSECT TRAP

MODEL: DTl

OSO

Thank you for purchasing the

DYNATRAP® flying insect trap!

IMPORTANT SAFETY INSTRUCTIONS

WARNING, When using electric appliances, basic precautions should always be followed, including the

following:

- To disconnect, turn all controls lo the off ('O") position, then remove plug from outlet.

- Unplug from outlet when not

use and before servicing or cleaning.

- To reduce the risk of electrical shock, do not put appliance in

water

or other liquid.

- This appliance is provided with double

insulation.

Use only identical replacement

parts.

- Connect only to a circuit that is protected by a ground-fault circuit-interrupter (GFCI).

See instructions for Servicing of Double-Insulated

Appliances.

INSTRUCTIONS FOR DOUBLE-INSULATED, CORD-CONNECTED APPLIANCES:

In a double-insulated appliance, two systems of insulation ore provided instead of grounding. No

grounding

means is provided

on a double-insulated appliance, nor should a means for grounding be added to the appliance. Servicing of a double-insulated

appliance requires extreme core and knowledge of the system, and should be done only by qualified service

personnel.

Replacement ports for a double-insulated appliance must be identical to those ports in the

appliance.

IMPORTANT SAFETY INSTRUCTIONS

Please read these instructions before using the DYNATRAP® Insect Trap and keep for future reference.

l. Always turn unit off and disconnect plug before servicing, cleaning, or changing bulb.

Do not position the unit near heat, gos, oil or other flammable

materials.

3. Place product out of reach from

children.

4. Never operate this product if it hos a damaged cord or plug, ii it is not working properly, ii it hos been dropped or

damaged, or if ii hos been dropped into

water.

5. This product is equipped with 2-conductor cord and 2-prong polarized plug as

safety feature. This plug will fit in a

polarized outlet only one way. If the plug does not fully lit in the outlet, then reverse the plug. If it still does not lit,

then contact a qualified

electrician.

To reduce the risk of electrical shock, only plug into a properly installed outlet.

Do not attempt to defeat this safety feature.

Do not insert fingers or any foreign objects into the unit while ii is connected to an electrical outlet.

Collected insects within the unit may contribute to fire, so clean insects from the unit

frequent~.

8. Do not clean this product with water

spray.

Do not place where ii con foll into water, or near flammable materials.

Do not touch fan while in

motion.

l 0. Do not abuse cord--never carry or hong

unit

by cord or yank it to disconnect from receptacle. Keep cord away from heat,

oil, or sharp

edges.

11. Extension cords used with this product must be marked with suffix letters "W-A" and with a tog stating "Suitable for Use

with Outdoor Appliances".

12. Use only extension cords that hove plug and receptacles that match the product plug. Replace or repair damaged cords.

INSTALLATION & OPERATING INSTRUCTIONS

Unpack

unit.

Save carton for off-season storage (if

needed).

Plug cord into on outlet or UL listed extension cord as described in "IMPORTANT SAFEIY

INSTRUCTIONS".

Hold the Power switch on the side of the revolving rotation

door.

Twist the unit lo the

"Power ON" position. When you hear a 'click", the machine is turned on. For best

catch

results leave unit on at all times, except when cleaning or

servicing.

Catch role activity will be higher al night. For best catch results ii is recommended lo

keep the unit away from competing light sources. Intended for household use only.

It is recommended to place the unit at least 10 to 20 feet away from where people will be

sitting.

This unit is all-weather resistant -designed for outdoor use including rainy

conditions.

CLEANING

Frequent cleaning will prolong the life of the unit, ensure lire prevention and provide for more efficient operation.

Be sure to clean the unit once per week

To clean, hold the switch on the revolving rotation door and turn it lo the "POWER OFF"

position.

After hearing the

'click",

the machine is turned

off.

Unplug the unit.

3. For weekly cleaning, remove the screw securing the retaining cage and then twist the cage clockwise. Remove any buildup from

the inside of the retaining cage and fan with a brush

(included).

4 For major cleaning, remove the four screws securing the fan housing to the light housing. After removing the screws, gently

pull the fan housing away from the light

housing.

Using a soft brush, remove dirt and debris from the light housing. Once the

cleaning process has been completed, align the screw holes in the fan housing with the screw holes in the lighting unit and

tighten the screws to the base of the lighting unit.

When replacing the retaining cage - DO NOT press/push against the screen windows.

REPLACING BULB

The light bulb life expectancy is approximately 3,000 hours (or about 4 months), and should be replaced regularly lo ensure optimal

UV effectiveness. Even though the bulb's light may be visible to you, its ability to attract insects diminishes over

lime.

Turn power switch to "off" position. UNPLUG UNIT, and allow bulb to cool before replacing.

Remove the screw securing the retaining cage and then twist the cage clockwise. Turn the unit upside down.

Remove

the

four screws securing the fan housing to

the

light

housing.

After removing the screws, gently pull the fan housing

away from the light

housing.

Using

soft brush, remove dirt and debris from the light housing. Once the cleaning process has

been completed, untighten the screw securing the base of the light bulb to the light housing. Slide the metal bracket to the side.

Cover the bulb with a cloth to protect your finger and

hand.

Grasp the bulb (with your hand and fingers protected by the cloth)

and gently pull the bulb from the socket.

Remove any debris from the lamp socket with a brush before inserting the new bulb. Replace the metal plate over the base of

the bulb and tighten the retaining screw.

Align the screw holes in the fan housing with the screw holes

in the lighting unit and lighten the

screws

to the base of the

lighting unit.

Replace the retaining cage at the bottom of the unit.

Replacement fluorescent bulbs can be found at your local retailer

or con

ordered directly from

DVNAMJC.

by colling

1-877-403-TRAP (8727) or visiting www.Jynotrap.com

HOW THE DYNATRAP® INSECT TRAP WORKS

Flying insects are attracted to the unit by UV light and CO2 that

generated by the photo-catalysis between the UV lamps and spe-

cial TI02 coating. The fan then pulls the insects into the screened

base, trapping them until they dehydrate and

die.

The base can be

removed, allowing the contents to be periodically emptied into

the trash. The see-through screen shows the insects trapped in the

compartment, alerting you when the net needs to be

emptied.

TROUBLESHOOTING

Problem:

Possible cause:

Correction:

Bulb does not illuminate

1. No electrical

power.

1. Che<k plug and receptacle and fuse or circuit breaker.

and fan does not

spin.

2. Che<k to make sure power is switched to the

"on" position.

Bulb illuminates, but fan

Shorted fan.

1. UNPLUG UNIT: Examine fan to see that it is free from

does not

spin.

foreign material, dirt or build-up of dead insects.

Clean unit as in "CLEANING" section.

Fan spins, but bulb does

Bulb not seated

1. Che<k all sockets for proper bulb seating and alignment.

not

illuminate.

properly.

2. Replace bulb if needed following instructions under

Burnt out bulb.

"Replacing

Bulb".

LIMITED WARRANTY

DWNlft\lC.

warranties lo the original purchaser that this product is free from defective materials and

workmanship. This warranty is limited lo remedy any defective part for a period of one year from date of

original date of purchase. Retain your original receipt as proof of purchase. This warranty does not apply

to the light bulb, nor lo, in our judgment, misuse or abuse. If this unit has been altered, no warranty is in

force. This warranty does not apply

this unit is purchased outside the United States, excluding Canada

and Mexico. In no case shall

DWNlft\)C.

be liable for any accidental, punitive, consequential, or any other

damages of any kind for breach of this or any other warranty, expressed or implied, whatsoever. Some

states do not allow limitation an how long an implied warranty lasts, so the above limitation or exclusion

may not apply to you. This warranty gives you specific legal rights, and you may also have other rights

that vary from slate lo stale.

PARTS

ACCESSORIES AVAILABLE

PART

41050

DESCRIPTION

7-Watt Replacement Fluorescent Bulb

piece)

Fan Blade and DC Motor Ultra-Long Life Replacement

Retaining Cage

41052

41053·DT1050

41061

Lorge Capacity Net (lo be used instead of the Retaining Cage, suitable for extra large catch performance)

1 ~

"11C.

Dynamic Solutions Worldwide, LLC

12247 W. Fairview

Ave.

Milwaukee, WI 53226

Phone:

414-431-2819

Toll free: 1-877-403-TRAP (8727)

Toll free fox: 877-403-3293

Email:

[email protected]

Visit us online at www.dynatrop.com

Dynamic Solutions Worldwide,

LL(

SAVE THESE INSTRUCTIONS

lntertek