ADEMCO 4192CPM Petunjuk Pemasangan dan Pemeliharaan

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan dan Pemeliharaan untuk Alarm Asap ADEMCO 4192CPM. ADEMCO 4192CPM 4 halaman. Addressable ionization smoke detector

Halaman Cetak

P-Mc,~

4192CPM Addressable

Ionization Smoke Detector

Installation and Maintenance

Instructions

Before instalkng detectors, please thoroughly

read the suppoting

Ademco control panel installation instructions,

which

provide detailed information on detector spacing, placement, zones, and special applications.

Copies of the installation

instructions

are available from Ademco. NFPA 72 and NEMA guidelines should also be observed.

Use this smoke detector only with panels that suppofl the detector's maintenance

feature:

ADEMCO VISTA 150, First Aleti FA1600C.

GENERAL

DESCRIPTION

The Model 4192CPM

dual-chamber

ionization

smoke detecto. uses a stat(>-of-the-art unipolar sensing chamber. This

detector is designed to provide open area protection and to be used with compatible

UL-hsted Ademco control panels.

An LED on each detector flashes every ten seconds. This LED can be Iatc!ted on by code command from ceflain con-

trol panels to indicate an alarm. [t can also be unlatched to the normal blinHng condition by the same control panels.

The 4192CPM

detector is intended for use in an Ademco 2-wire polling loop system. It uses two screw terminals for

connection

to the system. Both detector power and communication

betwe!en detector and control panel are accom-

plished over the same two wires.

SPECIFICATIONS

Base Diameter

5.0 inches (127 mm)

Cover Height

3.0 inches (76 mm)

Cover Diameter

3.15 inches (80 mm)

Loop Voltage Range:

7to 14VDC

Standby Current (max.):

1.56 mA (LED off); 3.56 mA (LED on)

Operating Temperature

Range:

5° to 131°F (-15° to 55°C)

NOTE

Do not install in locations where normal temperature

exceeds 120°F

(49"C)

Loop Unit Load:

MOUNTING

INSTRUCTIONS

Each 4192CPM

detector is supplied with a mounting

bracket tit that permits the detector to be mounted using several

techniques.

1. Units may be mounted directly to a 3-inch or 4-inch, 1-1/2-inch

deep octagonal

electrical

box using the supplied

mounting bracket (See Figures 1 and 2).

2. Units maybe

mounted to a 4-inch square electrical box by using a plast~?r ring with the supplied mounting bracket.

,,,fl~g$yziE;sT

~>y

.u...EmARRow,x\w,~

;" ~ ~

";:&$

..,-

Figure l.. Flush Mounting of Detector on Octagon

Box.

Hgure 2. Detector Mounting Bracket.

AD400-I 2-00

156-721-04

Ademco, 165 Hleen Way, Syosset, NY 11791

A7E2%3-02